1995 Chevrolet Ls on 2040-cars

Auto blog

Why does the Corvette Stingray have so many vents? Here's why

Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.

GM recalling over 243,000 crossovers over possible seat belt defect

2010 Buick Enclave - Click above for high-res image gallery
The summer of 2010's recall hit parade continues unabated today, with General Motors having just announced that it is asking 243,403 owners of its 2009-2010 Lambda crossovers to bring their three-row haulers in for inspection. The culprit? Second-row seat belts in select Buick Enclave, Chevrolet Traverse, GMC Acadia, and Saturn Outlook CUVs have "failed to perform properly in a crash."
According to GM, a second-row seat-side trim piece is to blame, as it can impede the upward rotation of the buckle after the seat is folded flat. As a result, if the buckle makes contact with the seat frame, cosmetic damage can occur, potentially requiring additional force to operate the buckle properly. So far, no great shakes, but in the process of applying that additional force, the occupant may push the buckle cover down to the strap, potentially revealing and depressing the red release button. As a result of this, the belt may not latch, or in certain cases, it may actually appear to be latched when, in fact, it isn't.