1986 Chevrolet Caprice Classic on 2040-cars

Auto blog

GM won't sell 2014 Chevrolet SS in Canada

Allow us to be the first to extend our condolences to our friends to the north. General Motors has announced the 2014 Chevrolet SS will not be available in Canada. The Globe and Mail reports the automaker has confirmed the high-performance sedan won't hit Canadian dealers, though GM hasn't offered up any reasoning as to why that is.
Buyers here in the US of A, meanwhile, can look forward to getting their hands on the 415-horspower, rear-wheel drive SS by late summer. Something tells us it won't be long after that before Canadian officials start seeing individually imported 6.2-liter V8 four-doors in their neighborhoods. Fortunately, Canadian buyers will still be able to take home the 2014 Chevrolet Corvette. The C7 bowed at the Canadian International Auto Show last week, reportedly drawing sizable crowds and interest.

Why does the Corvette Stingray have so many vents? Here's why

Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.