2013 Se Used Certified Turbo 1.6l I4 16v Fwd Suv on 2040-cars

Auto blog

Ford F-100 'Snakebit' shown off by Gene Simmons and Shannon Tweed at SEMA

Ford, along with KISS bassist Gene Simmons and his wife, Shannon Tweed, used SEMA as a backdrop to pull the covers off Snakebit, a 1956 Ford F-100 pickup truck that's been updated with Shelby Mustang-derived styling bits and a 5.4-liter supercharged V8 engine. All 550 horsepower are funneled through a six-speed manual gearbox to the rear wheels.
Underneath the custom bodywork sits a chassis that's been stretched five inches and a bed widened and bedecked with billet machined pieces that are supposed to look like wood. The 20-inch rear and 18-inch front wheels ape those of past Shelby Mustang models. The interior is swathed in two-tone leather with a bench seat designed to look - try to act surprised - like a Shelby Mustang.
Like what you see? Bidding for the truck will take place in 2014 at an unspecified Barrett-Jackson event (we'd assume Scottsdale). Proceeds will be used to help build a children's hospital in Saskatoon, in the province of Saskatchewan, where Ms. Tweed grew up. See the high-res gallery above and the press release down below for more.

Ford opens the doors on its Swedish rally skunkworks

It's always amazing to see how different kinds of racecars are made. Formula One racers are often constructed in modern architectural marvels that hint at some of the cutting-edge technology going into the racing. Conversely, rallying is all about sliding around on a varied course as fast as possible, but it often leaves a vehicle caked in mud. So it makes some sense Olsbergs MSE, or simply (OMSE) rally car shop in Nynashamn, Sweden, shows technological sophistication in a more down-to-earth setting. It builds Ford Fiesta ST racers for Global Rallycross there, and this new video gives viewers a tour through the work.
Former rally driver Andreas Eriksson runs OMSE. These days instead of racing, he and the company's 46 employees are building Ford racers from scratch. A ton of work goes into constructing each one, and according to Eriksson, it takes 400 hours to complete each body. At times, things are so busy that some of the technicians live in the shop in apartments that are on premises. There's even a restaurant to keep them fed. Sadly the dyno room is empty during this visit, though.
By the time OMSE is done, a rallycross car might resemble a Fiesta ST on the outside, but as you see in the video, it's a completely different beast underneath. Check out the work it takes to build one of them, and scroll down to read more about it in the official release.

Ford recalling 370,000 Crown Vic, Grand Marquis and Town Car models

The Detroit News is reporting that Ford will recall some 370,000 Crown Victoria (pictured), Mercury Grand Marquis and Lincoln Town Car vehicles from model years 2005 through 2011, for an issue regarding the lower intermediate steering shaft. 355,000 of the vehicles in question were sold in the US, with the other 15,000 sold in Canada.
The report indicates that corrosion of the lower intermediate steering shaft could cause a "loss of steering," presumably because of a partial or complete failure of the part. The report points out the dealers will inspect and replace the offending steering component for recalled cars, and may also secure a lower steering column bearing and replace the upper intermediate steering shaft as needed. The company is unaware of any reports of the faulty part causing any accidents or injuries.
Ford helpfully lists states in which corrosion is more likely to have taken place, mostly in the Snow Belt, as you might guess. Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, Wisconsin, West Virginia, and the District of Columbia are listed.