2000 S10 Extreme Pickup on 2040-cars

Auto blog

GM recalling 70k Chevy Malibus, Pontiac G6s over steering issue

A problem with the power steering system in the Chevy Malibu and Pontiac G6 has prompted General Motors and the National Highway Traffic Safety Administration to issue a recall for an estimated 69,633 vehicles. The issue revolves around the electric power steering assist, which could suddenly fail and increase the risk of a crash, especially at low speeds where the power steering is most helpful. The recall affects 2006-2007 Chevy Malibu sedans and Malibu Maxx wagons (specifically those manufactured between April 1, 2006, and June 30, 2006), as well as the Pontiac G6 (which was offered as a sedan, coupe or convertible) from the same model years and manufactured from April 18, 2006, to June 30, 2006. Owners of the affected units can expect to hear from the manufacturer with instructions to bring in their vehicles to their local dealers to have the torque sensors in the power steering system replaced. RECALL Subject : Sudden Loss of Electric Power Steering , 1 INVESTIGATION(S) Report Receipt Date: FEB 04, 2015 NHTSA Campaign Number: 15V064000 Component(s): STEERING Potential Number of Units Affected: 69,633 Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2006-2007 Chevrolet Malibu and Malibu Maxx vehicles manufactured April 1, 2006, to June 30, 2006, and 2006-2007 Pontiac G6 vehicles manufactured April 18, 2006, to June 30, 2006. In the affected vehicles, there may be a sudden loss of electric power steering (EPS) assist that could occur at any time while driving. CONSEQUENCE: If power steering assist is lost, greater driver effort would be required to steer the vehicle at low speeds, increasing the risk of a crash. REMEDY: GM will notify owners, and dealers will replace the torque sensor assembly, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Chevrolet customer service at 1-800-222-1020 or Pontiac customer service at 1-800-762-2737. GM's number for this recall is 14772. Note: This is an expansion of recall 14V-153 to cover additional vehicles built between April 1, 2006 and June 30, 2006. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

GM seeks national mandate for zero-emissions cars

DETROIT — General Motors says it will ask the federal government for one national gas mileage standard, including a requirement that a percentage of auto companies' sales be zero-emissions vehicles. Mark Reuss, GM's executive vice president of product development, said the company will propose that a certain percentage of nationwide sales be made up of vehicles that run on electricity or hydrogen fuel cells. GM says a nationwide program modeled on such a requirement in California could result in 7 million electric vehicles, or EVs, on U.S. roads by 2030. California wants 15.4 percent of vehicle sales by 2025 to be EVs or other zero emission vehicles. Nine other states, including Maryland, Massachusetts, New Jersey and New York, have adopted those requirements. In January, California Governor Jerry Brown set a target of 5 million zero-emission vehicles in California by 2030. The Trump administration criticizes California's ZEV mandate, saying it requires automakers to spend tens of billions of dollars developing vehicles that most consumers do not want, only to sell them at a loss. Reuss told reporters that governments and industries in Asia and Europe "are working together to enact policies now to hasten the shift to an all-electric future. It's very simple: America has the opportunity to lead in the technologies of the future." A national mandate also would create jobs and reduce fuel consumption, CO2 emissions and "make EVs more affordable," Reuss added. GM, the nation's largest automaker, will spell out the request Friday in written comments on a Trump administration proposal to roll back Obama-era fuel economy and emissions standards, freezing them at 2020 levels instead of gradually making them tougher. Under a regulation finalized by the Environmental Protection Agency at the end of the Obama administration, the fleet of new automobiles would have to get 36 miles per gallon by 2025, 10 mpg higher than the current requirement. But the Trump administration's preferred plan is to freeze the standards starting in 2021. Administration officials say waiving the tougher fuel efficiency requirements would make vehicles more affordable, which would get safer cars into consumer hands more quickly. GM on Thursday said it doesn't support the freeze, but wants flexibility to deal with consumers' shift from cars to less-efficient SUVs and trucks.

Surprise! GM putting aluminum in next-gen pickups

Last month, General Motors launched a series of ads touting the benefits of steel over aluminum – specifically, with regard to the Chevy Silverado versus the Ford F-150. (Kind of. We're not sure what a grizzly bear has to do with anything.) We took issue with the ads, with editor in chief Mike Austin saying they "reek of insecurity, and distract from the Silverado's strengths that could be used for positive advertising." But what bothers us more, is that yet another report surfaced claiming anti-aluminum GM will indeed use the weight-saving material in its next-generation fullsize trucks. On Tuesday, GM announced a $877-million investment for its truck plant in Flint, MI. But Reuters says that huge overhaul is because the trucks will use "substantially different equipment than the tools GM uses today." The report specifically states, "People familiar with the company's plans say GM's next-generation pickups and SUVs will make use of various materials, including aluminum and lightweight steel, to shed weight and gain fuel efficiency to meet tougher federal standards." The Silverado already uses a few aluminum components in the engine and hood, and if more widespread use will help GM build its best fullsize trucks ever, then that's great. Honestly, we have no reason to doubt that aluminum will be used in the next Silverado and GMC Sierra. We just hope GM remembers that nothing is ever truly deleted from the bowels of the Internet when it launches the subsequent "look how great aluminum is!" campaign. Related Video: News Source: Reuters Green Plants/Manufacturing Chevrolet GM GMC Truck aluminum steel