1981 Corvette on 2040-cars

Auto blog

2016 Camaro gets most revealing tease yet

Chevrolet started its long teaser campaign for the 2016 Camaro by just revealing the exhaust manifold and front frame, but as time has passed the company has slowly unveiled more. In the latest glimpse ahead of the pony car's May 16 debut, we're actually getting to see the model's profile completely undisguised. As suggested by the recent tease of the rear and hood, the 2016 Camaro wears a sharper, more angular design than the current model. This is especially the case when you look at the taut lines making up the rear. Chevy claims that the new shape underwent 350 hours of wind tunnel tests to be able to generate left lift, improve cooling and reduce wind noise in the cabin. A smooth underbody pan is among the aerodynamic tweaks, and it runs from underneath the front grille to the center of the Camaro. Chevy asserts that all of the changes at the front help reduce lift by 30 percent. Related VIdeo: 2016 Camaro is all about the Aero Total aerodynamic lift improved by 30 percent for improved stability 2015-05-11 DETROIT – After 350 hours of wind tunnel testing – often 24 hours a day – the new Camaro will slip more easily through the wind, and drivers of the Camaro SS will experience a marked improvement in reduced aerodynamic lift. These changes illustrate the lengths the aerodynamics team went to for improved performance, stability, cooling and lower wind noise intrusion "The importance of aerodynamics increases exponentially as we increase vehicle performance," said Kirk Bennion, Exterior Design manager. "As engine output increases, we need more engine cooling. As acceleration and top speeds climb, we need to reduce lift for better high-speed stability. However, we cannot make any changes at the expense of increasing drag, which can hurt fuel economy. "To balance these different aerodynamic targets, we tested literally hundreds of changes on the new Camaro, millimeters at a time." For example, the initial design called for the lower grille bars to be set at a 20-degree angle to the horizon. However, after meticulous testing, the team improved engine-cooling airflow by 1 percent by shifting the angle to 13 degrees – a change that achieved the airflow target while maintaining the original grille design. And rather than a traditional front air dam to reduce aerodynamic lift, the team developed a flush belly pan that stretches from the front grille to the center of the vehicle.

Expect greater differentiation in GM's next-generation SUVs

General Motors says its next-generation Chevrolet Tahoe, Suburban, GMC Yukon and Cadillac Escalade models will offer shoppers improved interior differentiation. Car and Driver recently caught up with Chris Hilts, GM's creative manager of interior design, who said that the cabins will all feature unique instrument panels, consoles, center stacks and switchgear moving forward. Apparently GM is now aware that consumers may be bothered by the fact that today's $85,000 Escalade has effectively the same cabin as a $45,000 Tahoe. Hilts says SUV buyers want more refinement than their pickup purchasing counterparts - and those same buyers also want their SUVs to have more exterior differentiation between the company's Silverado and Sierra pickup lines. Shocking.
That all sounds good to us, but we've heard this song and dance before. GM made big waves about how different the new-for-2013 Silverado and Sierra would look from each other, but judging by what we've seen so far, GM's stylists are painting in shades rather than with the full spectrum. For more on the what to expect out of GM's new SUVs, click on the C/D link below.

Recharge Wrap-up: NEDC's NOx problems, autonomous Chevy Volts

The International Council on Clean Transportation (ICCT) found a significant difference in NOx emissions in Euro 6 diesel cars in NEDC and WLTC testing. While 88 percent of the cars tested met emissions standards for NEDC, NOx emissions averaged five times higher under WLTC, with only 27 percent of vehicles under the limit. WLTC is considered to be a more realistic driving cycle, using hot starts and factoring a higher top speed as well as harder and more frequent accelerations than the NEDC. Read more at Green Car Congress.GM Canada will build a fleet of autonomous 2017 Chevrolet Volts. The self-driving Volts will be deployed for testing at GM's Warren, Michigan Technical Center. Employees will be able to use a carsharing app to reserve a car, which will then drive itself to the set destination. The project will allow GM to collect important data and experience to help the company more quickly develop autonomous driving technology. Read in a press release more from GM Canada, or at Green Car Congress.Carwatt is showing an electric Renault Trafic powered by second-life batteries at the COP21 environmental summit in Paris. The lithium-ion batteries used to power the EV were recycled from other Renault EVs. With the electric Trafic, Carwatt – a company that converts vehicles to use electric power – aims to demonstrate the "circular economy" of batteries, which can provide more value through a longer lifecycle. Read more in the press release below. Carwatt presents a unique automotive application for second-life batteries from electric vehicles. On the sidelines of the COP21 summit, in the Solutions Gallery running from 2 to 9 December 2015 in Le Bourget near Paris, Carwatt and its partners —Renault, Paris City Council, BPI France, the Ales Ecole des Mines Engineering School, and the Bobigny Business Campus — are showing a very special electric Renault Trafic. This prototype vehicle, the only one of kind in the world, is powered by second-life lithium-ion batteries recycled from Renault electric cars. Circular economy at work with electric vehicles When, over time, the batteries of a Renault electric vehicle fall the performance threshold specified for their initial automotive power duty (around 75% of initial capacity), they can still provide valuable service in "second-life" applications before end-of-life disposal at a recycling centre. Experiments are already under way on power storage applications, for example.