1983 Porsche 944 Base Coupe 2-door 2.5l With Lsd Transaxle M220 on 2040-cars

Auto blog

Porsche 918 Spyder gets tiny recall for rear control arms

As the recent US recall of a single Koenigsegg Agera shows, even low-production supercars aren't immune from safety campaigns. Now, there's another example that even the fastest cars can have their faults. The Porsche 918 Spyder is a pretty fantastic vehicle for its ability to mix hybrid fuel economy and incredible amounts of power, but Porsche has a problem on a few units of its halo model.
According to the recall document from the National Highway Traffic Safety Administration, Porsche needs to inspect and possibly repair five 918s in the US because the rear axle control arms may break, which could cause a loss of control while driving. In the full defect notice, Porsche says that it first noticed the problem on June 26 when the parts failed during "heavy duty durability testing (extreme race conditions)" at the Nardo test track in Italy. It transported the components back to the company's lab for inspection, and on July 18 it issued a stop-sale to inspect the suspension parts on the supercar. The automaker also contacted owners by phone to warn them not to use the car on track, until repaired.
The affected 918s will be inspected, and if the cars have the bad parts, the control arms are will be replaced. Obviously, this will be done at no cost to owners. According to a Porsche spokesperson speaking to Autoblog, in addition to the five US cars potentially affected, there were 45 worldwide. All of the cars have now been checked. Scroll down to read the report from the regulator or download the full defect notice as a PDF, here.

Porsche testing new 911 GTS

Porsche may have one more vehicle in its stable with the GTS moniker, if these spy shots are any indication. They show off the presumed 911 GTS lapping the track - the model meant to slide in under the GT3 to be a bit more driver-friendly but still very fast alternative to a stock Carrera.
At first glance, it might look like any other 911, but the devil is in the details. The most obvious among the differences are two centrally mounted exhaust outlets, rather than the ones closer to the corners on most of the current models. They also aren't perfectly in the center like the GT3. The taillights are also somewhat thicker than the current ones, and the rear decklid is split into three exposed sections.
This is the third time we've seen the presumed GTS. The first was as a coupe late last year. Then it showed up again in March testing in convertible form. Although, that version also sported fender vents at the rear.

Porsche wants you to 3D print your own Cayman

Have you got access to a 3D printer? Well lucky you, because as we're rapidly learning, the possibilities are virtually endless. And if your tastes lean towards the automotive (as we'd assume they do if you're reading this page), we've got good news.
Porsche has just released 3D printing data for the Cayman S so you can three-dimensionally print out your own and customize to your heart's content. Now Porsche hasn't specified just to what scale the data will allow you to print your Cayman, but we have a feeling that'd mostly be limited by the size of the printer at your disposal. Check it out in the video below and follow the link to the Porsche site to download the file.