1970 Ford Torino Cobra Gt 2-door Sportsroof Rare J-code 429 Ram Air #'s Matching on 2040-cars

Auto blog

Ford offering factory-spec EcoBoost reflashes that don't void warranty*

Buy a supercharger or cold-air kit from Ford Racing and a Performance Calibration handset comes with it to reset the ECU for the upgrade. Now Ford Racing is offering the ProCal handset a la carte for $595, allowing you to reflash the ECU on your EcoBoost-equipped ride to extract more of its inherent capabilities without any additional upgrades. It gives you control of variables such as throttle response, idle speed and turbo wastegate control, among others. As for that warranty asterisk, the press release says enthusiasts can up the power "while maintaining the Ford-backed limited warranty." However Ford Motor Co. and Ford Racing are separate entities, and, best we can tell, when you reflash the ECU, your Ford warranty gets supplanted by the Ford Racing warranty. Say you bought a 2014 Ford, that means your five-year, 60,000-mile warranty becomes Ford Racing's three-year, 36,000-mile warranty, if we're reading the fine print correctly. If you have an older car and have driven more than 36,000 miles, then your warranty options are kaput, at least as far as a Ford in-house option. If have warranty concerns, you might also want to consider having a dealer perform the reflash, or at least ask about it. Once you've got past the small print, what about the numbers? At the moment Ford Racing offers tunes for the 2.0-liter EcoBoost in the Focus ST and the 1.6-liter EcoBoost in the Fiesta ST, and we're told there's a 90-pound-foot boost in torque at the crank after you've pressed the right buttons. Anecdotal evidence from a commenter at Road & Track says he went from 252 horsepower at the flywheel to 254 hp at the wheels, and 272 lb-ft at the flywheel to 354 lb-ft at the wheels, but we can't be sure that his adjustments were within Ford Racing specs. Your mileage, naturally, may vary. What about custom numbers for the 2.3-liter EcoBoost in the 2015 Ford Mustang? They aren't ready yet, but we're told we'll get something by the end of next year. Featured Gallery 2015 Ford Focus ST News Source: Ford, Ford Racing via Car and Driver Aftermarket Ford Technology ecoboost ford focus st ford fiesta st ford racing

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

Daimler consulting with Ford about 3-cylinder engines

Soon enough, Ford will offer its 1.0-liter EcoBoost three-cylinder engine under the hood of the Fiesta here in the United States, building on the success of the small powerplant overseas. In fact, this success has caused other automakers to take notice, and according to Automotive News Europe, Daimler is now talking to Ford about this engine for use in its own products.
In other markets, Ford offers the 1.0-liter mill under the hood of the Focus (we had the chance to sample this package on our home turf), as well as the B-Max MPV. For this new collaboration, Daimler would use the turbo-three in the next-generation Smart ForTwo, as well as the Renault Twingo, which the German automaker will be collaborating on as part of its alliance with Renault-Nissan. Speaking to AN, a Mercedes-Benz engineer called the 1.0-liter mill an "interesting and impressive engine."
In exchange for details about the EcoBoost inline-three, Daimler will supply Ford with information regarding its Euro6 stratified lean-burn gasoline engine, which is found in the new E-Class sedan.