1951 Chevy Truck on 2040-cars
Grand Forks, North Dakota, United States
|
1951 Chevy
1951 Chevrolet 3- window Step side Truck. This truck has been complete overhauled for appearance and performance. It has a custom chassis with a Volare front suspension, custom back-halved rear suspension (tube chassis, coil-overs, narrowed Ford 9” rear end with 31 spline axels and 3.73 gears built by D7R Driveline), New Centerline Wheels and tires (rear 21.5 inches x 33 inches), Custom body modifications (recessed firewall, new door handles, gas tank opening filled, hood seems and peaked, custom high polished diamond plate bed and wheel tubs, all steel body with zero rust. Vintage hear, air, and defrost ( needs charging and vents installed). Has a new chrome front bumper and grill, filled panel, fiberglass rear roll pan with class III hitch, all new rubber seals, weather strips, fender welting, door handles, etc, new hinges and rebuilt radiator. ENGINE & TRANSMISSION The drive train is from a 1991 Chevy Truck, including steering column, cruise control, and wiring. It has a 350 V8 motor rebuilt and bored .030 over, with approximately 325-350hp. Other additions include new pistons, rings, rods, bearings, crank turned, 3 angle valve job on heads, new timing chain and gears, new cam (mild performance), new oil pump, original throttle body fuel injection, and custom Ram Air induction with air filter element. The transmission is a 700R4 transmission from a 1984 z/28 rebuilt with Corvette servos and 2000 RPM stall converter (built specifically for the trucks drive train, which is mated to a new 23” Lokar floor shifter. INTERIOR The interior is outfitted with Cadillac Coupe DeVille power split bench seats covered in Italian Leather with Italian leather coverings on door panels, cab liner, and head liner, custom color matched carpeting, and V butted windshield with auto dimming compass mirror.
|
Chevrolet Other Pickups for Sale
1953 chevy truck restomod top 10 all time winner for truckin magazine(US $67,900.00)
1955 chevrolet truck 3100 pickup chevy
1954 chevrolet pickup truck. beautiful restored california truck. rare survivor!(US $15,000.00)
1946 chevolet 3/4 ton pick up truck rat rod hot rod dodge ford chevy pickup(US $1,000.00)
1954 chevrolet 3100 pro-touring pickup truck(US $39,800.00)
Chevrolet k20(US $14,000.00)
Auto Services in North Dakota
Steele-Dawson Towing ★★★★★
Midnight Auto Repo & Repair ★★★★★
Boom Town Towing & Detail ★★★★★
Action Auto ★★★★★
Werner Automotive ★★★★
G & G New Holland ★★★★
Auto blog
GM recalls select Chevy Cruze, Sonic and Buick Verano models over airbag issue
Wed, 14 Nov 2012General Motors is recalling certain 2012 Buick Verano, Chevrolet Cruze and Sonic models due to a defect in the driver's airbag system. According to the National Highway Traffic Safety Administration, the airbag has a shorting bar which may contact two internal terminals. If that happens during a crash, the supplemental restraint may not deploy, increasing the risk of driver injury. The recall includes a total of 2,949 units.
GM will contact owners and replace the steering wheel airbag coil at no cost. At this point, it's unclear when the recall will begin, though owners may contact the automaker at 1-800-521-7300 for more information. You may also take a closer look at the full NHTSA notice below.
Camaro spy shots show subtly different grille, front fascia
Sun, 03 Feb 2013It looks like there some changes in store for the Chevrolet Camaro - the only thing is that we just don't know what Chevy has up its sleeve. Looking at these spy shots, we'd initially be inclined to think that there is just a minor facelift or a new special edition, but upon closer inspection, there are a few oddities about this car that definitely have us intrigued.
The most obvious difference on this prototype is the slightly restyled front fascia with a smaller lower air inlet and the two-bar grille. Then we get to some of the car's mysterious details. For starters, this fascia has the SS vent above the grille, but it looks to be blocked off. Granted this could just be a one-off piece used for testing. What really piqued our interest was at the rear of the car where it has quad exhaust outlets that are used on the ZL1. Could this be the LS7-powered Camaro that we reported on back in December?
At this point, your guess is as good as ours as to what we're looking at here, so let us know in the comments what you think this could be.
Why does the Corvette Stingray have so many vents? Here's why
Sun, 27 Jan 2013Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.