1992 Corvette Lt4 Stroked And Forged Internals on 2040-cars

Auto blog

More Corvette Stingray Factoids: Vanishing panel gaps and 26-mpg LT1

During January's Detroit Auto Show, we managed a longer than expected wandering tag-team interview with C7 Corvette chief engineering exec Tadge Juechter (pictured above), and LT1 engine boss Jordan Lee (pictured below). They are, quite honestly, two of the very nicest bigshot lads to ever walk the engineering corridors of an American manufacturer. Both are enthralled by what they're doing for a day job. So are we.
We've followed the pre-sale anticipation for the Chevrolet C7 Corvette Stingray like an Oreck vacuum yanking every speck of dirt from a well-trampled carpet. Everything is reportable and contains a grain of further knowledge about this dramatically important and cheered-for car, as it continues to be pressured into representing all that is superior about the American dream. The Corvette wears one heavy cloak.
So, most of what was talked about has been expertly reported already right here on Autoblog. But, looking through our notes again, both Jeuchter and Lee added facts to the buzzing mix.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.

Chevy Camaro is a good sport, wishes Ford Mustang Happy 50th

It was 1966 when Chevrolet launched its challenger to the wildly successful Ford Mustang, the Camaro. While the competition between the two brands was already healthy, the arrival of the Camaro set off one of the most intense, model-to-model rivalries in the industry.
That competitive spirit hasn't stopped Chevy and the Camaro from wishing Ford's iconic muscle car a Happy 50th Birthday as the Ford's April 17 anniversary rolls around. These two cars have been linked over the years, and while the rivalry took a break for a few years in the 2000s, today's competition between the Camaro and Mustang is as fierce as it's ever been.
You might recall that this friendliness when it comes to major milestones isn't too rare. Ford put on quite a display for General Motors' hundredth anniversary back in 2008. As the Camaro's fiftieth birthday approaches in 2016, we wouldn't be surprised to see the Mustang sending its best wishes to its Bowtie rival.