1981 Corvette Daily Driver Quality California Car--runs And Drives Great on 2040-cars

Auto blog

Why does the Corvette Stingray have so many vents? Here's why

Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.

Why Cadillac thinks it needs to succeed in Europe to sell cars elsewhere

Ward's Auto has taken an interesting look at the renewed focus General Motors is showing towards Cadillac in Europe. Susan Docherty, president and managing director of Chevrolet and Cadillac in Europe (pictured), says in order for the luxury brand to thrive in China, it first needs to succeed in the old country. The reason? Chinese buyers look to Europe for cues as to what's deemed worthy of the term "luxury." There are hurdles to the plan, however. In addition to the fact that the EU is flooded with high-end nameplates, GM doesn't necessarily have the distribution network in place to put buyers behind the wheel.
Combine that with persistent economic woes and Cadillac's checkered past marred by a lack of diesel engine options and a bankrupt distributor, and the road ahead for the brand looks like less of an uphill climb and more like a straight-up cliff face. But Docherty is optimistic and says she has a plan for the brand. We recommend heading over to Ward's for a closer look at the full read.