1956 Chevy 210 on 2040-cars
Ingalls, Kansas, United States
Vehicle Title:Clear
Trim: 210
Model: Bel Air/150/210
Mileage: 99,000
Drive Type: None
This is a 1956 Chevy 210 it has a lot of cancer in floor and trunk rest is minor and normal. I have most of original trim inner fenders interior hard parts, I do not have the hood or seat frames, the frame is excellent it has always been a Kansas car we bought it for parts but didn't really use any thing other than the hood, seats. It has been stripped down and primed it also has a good Kansas title that is signed and ready to go there is no drivetrain but it is a rolling chassis call 620 260 6551 with any questions this car is a builder if it doesn't sell we decided we are going to build it ourselves good luck
Chevrolet Bel Air/150/210 for Sale
Auto Services in Kansas
Victory Lane Auto Sales ★★★★★
Used Cars Kansas City ★★★★★
Thoroughbred Ford ★★★★★
Sutton-Kauffman Transmission ★★★★★
Summit Auto Body CARSTAR ★★★★★
Steven Ford of Augusta ★★★★★
Auto blog
Camaro spy shots show subtly different grille, front fascia
Sun, 03 Feb 2013It looks like there some changes in store for the Chevrolet Camaro - the only thing is that we just don't know what Chevy has up its sleeve. Looking at these spy shots, we'd initially be inclined to think that there is just a minor facelift or a new special edition, but upon closer inspection, there are a few oddities about this car that definitely have us intrigued.
The most obvious difference on this prototype is the slightly restyled front fascia with a smaller lower air inlet and the two-bar grille. Then we get to some of the car's mysterious details. For starters, this fascia has the SS vent above the grille, but it looks to be blocked off. Granted this could just be a one-off piece used for testing. What really piqued our interest was at the rear of the car where it has quad exhaust outlets that are used on the ZL1. Could this be the LS7-powered Camaro that we reported on back in December?
At this point, your guess is as good as ours as to what we're looking at here, so let us know in the comments what you think this could be.
Why does the Corvette Stingray have so many vents? Here's why
Sun, 27 Jan 2013Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.
This is your 2014 Chevrolet SS
Sat, 16 Feb 2013Think you've waited long enough for this? If so, then you'll want to savor the high-res photos we've so far been given of the 2014 Chevrolet SS, the first rear-wheel-drive performance sedan from The Bowtie in 17 years.
We all know its our version of the brand new VF-model Holden Commodore, but what's under the hood that earns the appellation "performance?" A 6.2-liter LS3 V8 engine producing 415 horsepower and 415 pound-feet of torque. That's 35 hp and lb-ft less than the same engine is expected to produce in the 2014 Chevrolet Corvette. Chevrolet says the sedan will get from 0-to-60 miles per hour "in about five seconds."
Shifting comes courtesy of a six-speed automatic with paddles on the steering wheel, while stopping arrive via four-piston Brembo calipers up front, a single sliding piston in back. The forged aluminum wheels are 19-inchers all around, each set supporting right around 50 percent of the sedan's weight, and the aluminum hood and trunk are meant to keep the center of gravity low.