4dr Cpe Auto Low Miles Coupe Automatic Gasoline 1.3l R Whitewater Pearl on 2040-cars

Auto blog

Mazda2 production fires up in Mexico

Mazda has officially kicked off production of the next-generation Mazda2 at the company's new factory in Salamanca, Mexico. Alongside the auto assembly plant, operations have also commenced at the facility's engine machining factory.
"With the start of production of the all-new Mazda2, operations underway at the engine machining plant, and an increase in our annual production capacity, we now have an even stronger production framework capable of supplying global markets with Skyactiv products of the same high quality level as those made in Japan," Mazda de Mexico Vehicle Operation's President Keishi Egawa said in a statement. "At the same time, we are pleased to be able to make a contribution to Mexico's further economic growth."
MMVO joins Mazda's Hofu Plant in Japan and the Auto Alliance factory in Thailand, which commenced Mazda2 production in July and September, respectively.

2014 Mazda CX-5 with 2.5-liter Skyactiv engine

Back in October, we compared the relative merits of two new and very good small crossovers: the 2013 Ford Escape and 2013 Mazda CX-5. The CX-5 we tested then had Mazda's 2.0-liter Skyactiv-G engine under its hood, and it managed to just edge out the EcoBoosted Ford despite being down by some 23 horsepower and 34 pound-feet of torque. Had it been available, the 2.5-liter Skyactiv engine that we recently had the opportunity to try out in the 2014 Mazda CX-5, it may have made that comparison even easier to call in the Japanese CUV's favor.
Clearly, if you're in the market for a reasonably sized crossover, the CX-5 should, at the very least, be on your test-drive list. The new engine offering will let buyers opt for a stronger powerplant, with 184 hp and 185 lb-ft on tap. On our second day in Austin's Hill Country - the first was spent quick-spinning the 2014 Mazda6 i Sport, you'll recall - we covered a couple of hundred miles and put the new CX-5 through its paces; here's what we turned up.
Driving Notes

Mazda engineers urging execs for more RWD models

According to Edmunds, Mazda engineers are pressuring the company to create more rear-wheel-drive models, in an effort to better differentiate itself from its rivals. This push is reportedly coming from middle and senior engineers within the company, and these folks at Mazda believe this rear-drive strategy would allow the automaker to produce more distinctive, fun to drive cars. Mazda discontinued the rear-drive (and rotary-engined) RX-8 a few years ago, leaving the MX-5 Miata as the company's only RWD offering.
As enthusiasts, we're fully on board with Mazda offering more rear-drive cars, but unsurprisingly, the company's top management isn't exactly keen on the idea - and with good reason. First and foremost, the cost associated with redesigning fresh architecture for new models would be very high, and considering the fact that Mazda hasn't exactly been raking in the dough lately, an expensive new venture like this doesn't make a whole lot of sense. What's more, Mazda's latest front-drive models - the Mazda3, Mazda6 and CX-5 - have been very well-received, and are helping the company gain sales momentum.
But that doesn't mean there aren't other options. Edmunds reminds us that Mazda is already partnering with Alfa Romeo on the next-generation Miata, and if this collaboration is successful, perhaps the relationship could bear additional fruit. After all, Alfa Romeo is said to be working on returning to its rear-wheel-drive roots, so Mazda's engineers might be able to make a case for more RWD goodness after all.