1965 Toyota Landcruiser Fj40 4wd on 2040-cars

Auto blog

Toyota recalling 342k Tacomas due to faulty seatbelt pretensioners

Toyota is voluntarily recalling 342,000 Tacoma Access Cab pickups, produced between 2004 and 2011. The wide-ranging recall is due to faults in the screws that attach the belt pre-tensioner to the belt retractor. There are concerns that the screws can loosen themselves over time, especially if the access door is opened and closed with too much force. It's important to note that the recall only covers the driver and front passenger seat, and is limited to just the Access Cab trucks. Other body styles aren't affected.
If the screws come loose, the pre-tensioner and retractor spring could separate from the belt entirely, which would be bad news in a crash. There's no mention of injuries or accidents due to the faulty pre-tensioners. Owners affected by the recall will be notified soon, and asked to come in for recall service.

Toyota recalling 20k 2014 and 2015 cars and CUVs with 3.5L engines

Toyota has announced a recall of roughly 20,000 vehicles covering the 2014 Avalon, Camry, Highlander (pictured) and Sienna, as well as the 2015 Lexus RX luxury crossover. The affected vehicles are all powered the 2GR-FE engine, which in layman's terms, is Toyota's well-regarded 3.5-liter V6.
According to Toyota's statement, a parts supplier might not have welded "the end cap on the right-hand fuel delivery pipe in the engine compartment" correctly, meaning fuel could leak. Leaking fuel, of course, increases the chance of an engine fire. That said, no fires, crashes or injuries have been reported due to the issue.
Owners will be notified to report to dealers, where techs will check the fuel delivery pipe and fit a replacement part as necessary.

Toyota mini doc chronicles Tundra towing Space Shuttle Endeavor

Toyota has worked up a quick video detailing the brand's involvement in the transportation of the Space Shuttle Endeavour last year. As you may recollect, the California Science Center ran into a hitch when it came to moving Endeavour from LAX to its new home. While most of the route would be covered by a robotically controlled transporter, one portion of the route directed the shuttle over an interstate. Unfortunately, the bridge across wasn't designed to stand up to the weight of the shuttle and its motorized sled.
The Science Center would have to remove Endeavour from its transporter and place it on a lighter, non-motorized sled. That's where longtime Science Center sponsor Toyota came in. As it turns out, the automaker had to prove to the California Science Center that a Tundra could actually tow the massive shuttle, so engineers put on a little demonstration with a stock truck pulling the equivalent weight over flat ground for the same distance. Once the Science Center was satisfied that the Tundra could pull it off, the move was green lit and the rest is history. Check out the short documentary below for yourself.