Cj7 Jeep on 2040-cars

Auto blog

7 months later, Jeep 'trailer hitch' recall still stalled

For the past few years, Chrysler and its CEO, Sergio Marchionne, have gone head-to-head with the National Highway Traffic Safety Administration and its boss, David Strickland, over the government safety agency's request for Chrysler to recall almost three-million Jeep vehicles due to what NHTSA says is a safety issue that has caused at least 51 deaths. After a three-year investigation and Chrysler's initial refusal to issue a recall because it deemed the vehicles safe and built to the day's federal requirements, last summer, the two parties compromised on a "voluntary campaign" to inspect 1.56 million vehicles, those being the 1992 to 1998 Grand Cherokee and 2002 to 2007 Liberty.
Those vehicles were designed with their gas tanks between the rear axle and the bumper, and NHTSA says that in rear-end collisions, damage to the fuel tank has caused fires responsible for those 51 deaths. The compromise reached last summer was that Chrysler would inspect 1.56 million vehicles and, "if necessary, provide an upgrade to the rear structure of the vehicle." Practically speaking, that meant Chrysler would replace aftermarket trailer hitches, but would take no action if a vehicle had a factory-installed hitch or an aftermarket hitch from Mopar.
A report in The Detroit News says the "voluntary campaign" is just now getting under way, with Chrysler saying last week that the design of the replacement part had been finalized and it was tooling up "to deliver the required volume." Seven months later, still in question is whether NHTSA will crash-test the fix engineered by Chrysler, noteworthy because not only did the vehicles in question pass every safety standard necessary to be cleared for sale at the time, there are still questions (to those of us on the outside) as to how the Jeeps at issue fare among their peers in such incidents. Either way, Chrysler and NHTSA apparently still disagree on the efficacy of the remedy itself: the carmaker says it might help in low-speed crashes but not high-speed collisions, a position the NHTSA is at odds with. All of this means the campaign doesn't yet have an end in sight.

Radical 2016 Jeep Wrangler suggested by job listings?

With most inside the industry expecting the next-generation Jeep Wrangler to arrive for the 2016 model year, it makes sense that the automaker would be looking for some choice candidates to to fill program openings as the off-roader goes through its development. A recent ad on Chryslercareers.com suggests to some that the lightweight Wrangler Stitch Concept, revealed just two months ago and shown above, provides some clues about the off-road icon's next iteration.
According to Automotive News, the job descriptions - which don't name the model specifically - hint that the next-generation Wrangler will benefit from a serious diet. The ads appear to seek those familiar with advanced high-strength steels, hinting that lightweight aluminum body panels may appear on the 4x4. In addition, there are suggestions that Jeep may fit the Wrangler replacement with air suspension, as seen on the Ram and Grand Cherokee, to retain ample off-road clearance yet lower that chassis to improve aerodynamics at highway speeds. The job postings reportedly also lend credence to the idea of a diesel Wrangler.
It seems every bit of the next-generation Wrangler is up for review, as it will be the first time this iconic model is redesigned under Fiat ownership. Questions remain whether or not the Jeep will retain its clip-down hood, easy-to-remove door pins and folding front windshield - loyalists expect them, but fuel economy and safety standards may crimp their cases for survival.

Jeep Wrangler's shift to aluminum could see production leave Toledo

The Jeep Wrangler may be a timeless design, but sooner or later, time will run out and Chrysler will have to replace it with a newer model more friendly towards the earth it's designed to traverse. That will, it seems, mean a shift to aluminum construction (whether just for the body or for the entire structure) - but what will that mean for the Wrangler's long-time home of Toledo, OH?
According to the latest pronouncements from Fiat Chrysler chief Sergio Marchionne, the shift to an aluminum Wrangler would likely mean moving production out of Toledo. "If the solution is aluminum," Marchionne told Automotive News, "then I think unfortunately Toledo is the wrong place, the wrong setup to try and build a Wrangler, because it requires a complete reconfiguring of the assets that would be cost-prohibitive."
Marchionne also indicated that, were Wrangler production to move elsewhere, it would find another line to take its place in Ohio. "One of the thing that we are dealing with now is what else we do with Toledo that fulfills our commitment to the city and to Ohio. I don't have a doubt that there will be zero impact on head count and employment levels and anything else." Jeep has built the Wrangler in Toledo since World War II, with the exception of six years starting in 1986 when it was built in Brampton, Ontario. The complex dates back to 1910 and currently produces the Wrangler and Cherokee. Past products have included the Wagoneer and Commanche as well as the Dodge Dakota and Nitro.