2013 Ford Mustang on 2040-cars

Auto blog

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

Watch these Australian Ford and Holden muscle cars duke it out

Australia's Motoring has put together a little video on two of the great performance vehicles available down under - the Holden VF Commodore HSV GTS and the Ford Falcon FPV GT R-Spec. And while both FPV and the Falcon might be on their way out, there's still plenty of time for a little head-to-head comparison between the two.
The cars aren't all that well evenly matched, though. The Ford boasts a 5.0-liter, supercharged V8, which the Aussies measure out at 449 horsepower and 420 pound-feet of torque. The HSV, though, with its Corvette-derived, 6.2-liter, supercharged V8 is just too powerful - 576 hp and 545 lb-ft of torque.
Predictably, it doesn't end too well for the Ford. As the guys from Motoring point out, the new VF Commodore is just too new and too good, with its extra power and its adaptive dampers (GM's excellent MagnaRide). Interestingly, Motoring did point out that the Holden's electric steering is better than the Ford's hydraulic steering, which is a lot like a Porsche purist saying they prefer water-cooled engines to air cooled.

Watch these videos of an NHRA racer's bodywork blowing off into a crowd

Just a few months ago, fan safety at racetracks was a hot topic following the last-lap NASCAR Nationwide Series crash at Daytona that sent large pieces of racecars into the grandstands injuring 33 fans. Now, a freak incident at a National Hot Rod Association event resulted in a drag racer's bodywork flying into the crowd at the NHRA Four-Wide Nationals in Charlotte over the weekend. The carbon-fiber body of Robert Hight's Ford Mustang funny car blew off toward the end of a run when his engine exploded, but fortunately, the two fans evaluated after the incident were later released without serious injury.
As you can see in the image above, the body flew high into the air before landing on a walkway in front of the grandstands, a bit of happenstance that likely gave most fans enough time and space to move out of the way. Scroll down to watch a couple of videos showing what happened, including one from a fan's perspective that also reveals what appears to be part of the body's metal bracing landing dangerously close to the crowd.