2006 Dodge Viper Srt-10 Coupe 2-door 8.3l Gts on 2040-cars

Auto blog

Chrysler investing $20M in Toledo plant to support 9-speed auto production

In 2011, Chrysler announced a $72-million investment in its Toledo Machining Plant to modernize production of the eight- and nine-speed torque-converters for automatic transmissions made there. That upgrade work won't be finished until Q3 of this year, but Chrysler has already announced a further $19.6-million investment to increase production capacity for the nine-speeders.
The extra units will be necessary because the nine-speed transmission they'll be mated to is going into three popular models: it will debut on the 2014 Jeep Cherokee, then go into the Chrysler 200 and Dodge Dart. The company predicted that this year alone it would sell 200,000 units equipped with the nine-speed tranny, and it is spending some $374 million in addition to the investment in Toledo to upgrade production capacity for it.
The work attached to this new investment won't begin until Q3 of 2014, and it will be finished by the end of that year. There's a press release below with all the details.

Chrysler minivans under investigation for stalling after fuel refill

According to the National Highway Traffic Safety Administration, at least one man has reported that his 2007 Dodge Grand Caravan stalled unexpectedly on the highway shortly after being refueled. The unidentified man who contacted NHTSA regarding the issue cited as many as eight similar instances reported by other drivers.
NHTSA has announced that it will launch an inquiry into this issue, which could affect as many as 160,000 minivans from Dodge and Chrysler that were sold in 2007 (or more, if a problem is found that extends to additional models years, we'd assume). As of yet, there's no formal investigation, let alone a recall, on these vans, as the agency is merely determining if further action is needed.
Two months ago, Chrysler recalled nearly 700,000 vehicles, the majority of which were minivans, from the 2008-2010 model years to replace ignition switches after an investigation found that their weak springs and detent positions could fool a driver into thinking the car was in the "Run" position, when it's actually in the "Accessory" position.

Dodge Challenger spied exercising supercharged Hellcat Hemi V8

One of the prime complaints against the Dodge Challenger is that, even in SRT8 guise, its 470 horsepower is responsible for hauling over 4,200 pounds of vehicle. For comparison, the 420 hp in the Ford Mustang GT only has to deal with 3,618 lbs. Things only get worse from there, as the higher-performance variants of both the Mustang and the Chevrolet Camaro are far more powerful than an SRT8 without adding on much heft.
So what is Chrysler to do? The correct answer is add a whole lot more grunt to its hefty two-door and even the odds. That's where the all-new Hellcat engine comes into play. We reported on this engine in May, and suggested that the Hellcat, a supercharged powerplant based on a 6.4-liter V8, would easily generate 500 to 570 hp and could likely arrive boasting more than 600 ponies.
Chrysler's ace in its sleeve has now been spied testing, with a number of Hellcat-equipped Challengers running the potent new engine both in more urbanized areas and under the sun of Death Valley. The hoods on these testers have been raised to accommodate the engine, and that camouflage over the fascias of these prototypes is there to hide a larger air intake. We also note what appears to be a new split grille under wraps. As for power output, our spies are now suggesting a Viper-equalling 640 hp from the Hellcat-equipped cars.