Dodge: Challenger Srt8 on 2040-cars

Auto blog

Dodge engineers trying to shoehorn Pentastar into Dart?

The fact that the Dart's launch has been a pretty dismal affair isn't what we'd call secret. Judging by its mounting inventories and poor critical reception, Dodge's successor to its unloved Caliber has struggled since it hit the market. And while both of those are difficult problems to address, at least their cause is well known - the powertrain.
Even Fiat-Chrysler CEO Sergio Marchionne has acknowledged that the powertrain options in the Dart are substandard, admitting at January's Detroit Auto Show that the powertrains are "less than ideal." Leading with the 1.4-liter turbocharged four-cylinder found in the Fiat 500 Abarth left a bad taste in the mouths of consumers thanks to the laggy engine and dead throttle response (to say nothing of the manual and dual-clutch gearboxes that needed more refinement). The addition of the 184-horsepower 2.4-liter Tigershark in the Dart GT has helped matters some, but apparently Auburn Hills doesn't think it's quite enough.
If rumors are to be believed - get that salt ready - a possible solution may be in the works. A report from Allpar is claiming that Dodge is considering fitting a Pentastar V6 into the Dart's engine bay. As the Mopar-obsessed website points out, the critically acclaimed Pentastar is available in three different sizes - 3.0 liters, 3.2 liters and the original 3.6 liters. We don't get the 3.0 here in the US, but the 3.2 can be found in the new Jeep Cherokee and the 3.6 has been seemingly fitted to every model Chrysler can shoehorn it into.

Dodge Challenger spied exercising supercharged Hellcat Hemi V8

One of the prime complaints against the Dodge Challenger is that, even in SRT8 guise, its 470 horsepower is responsible for hauling over 4,200 pounds of vehicle. For comparison, the 420 hp in the Ford Mustang GT only has to deal with 3,618 lbs. Things only get worse from there, as the higher-performance variants of both the Mustang and the Chevrolet Camaro are far more powerful than an SRT8 without adding on much heft.
So what is Chrysler to do? The correct answer is add a whole lot more grunt to its hefty two-door and even the odds. That's where the all-new Hellcat engine comes into play. We reported on this engine in May, and suggested that the Hellcat, a supercharged powerplant based on a 6.4-liter V8, would easily generate 500 to 570 hp and could likely arrive boasting more than 600 ponies.
Chrysler's ace in its sleeve has now been spied testing, with a number of Hellcat-equipped Challengers running the potent new engine both in more urbanized areas and under the sun of Death Valley. The hoods on these testers have been raised to accommodate the engine, and that camouflage over the fascias of these prototypes is there to hide a larger air intake. We also note what appears to be a new split grille under wraps. As for power output, our spies are now suggesting a Viper-equalling 640 hp from the Hellcat-equipped cars.

Dodge Scat Packages add Mopar performance upgrades in three stages

Dodge has revealed what it calls Scat Package Stage Kits that enhance the performance of the Charger and the Challenger equipped with the 5.7-liter V8, and the Dart equipped with the turbocharged 2.4-liter inline four-cylinder engine. The Scat Packs use Mopar performance parts that also can be bought separately. Most of the upgrades increase engine output, but Dodge somehow manages to not specifically mention the power gains associated with each Scat Pack.
The three Scat Packs offered for the V8-powered cars focus on higher power ratings, and each stage comes complete with a unique engine-management calibration to optimize output. Stage one comes with a cold-air intake and a cat-back exhaust; stage two adds a performance camshaft; and stage three really gives you the goods, adding ported polished cylinder heads and performance headers.
For the Dart, the Scat Packs focus on engine, transmission, chassis and brake upgrades. Stage one will net you a cold-air intake, a short-throw shifter and slotted rotors with performance brake pads; stage two adds a cat-back exhaust system and an engine-management calibration to increase output by taking advantage of premium-octane gasoline; and stage three adds 13-inch vented brake discs up front clamped by four-piston calipers, suspension with adjustable springs and struts and performance front and rear antiroll bars.