2007 Toyota Sienna Le - 3.5l Auto - Salsa Red Pearl on 2040-cars

Auto blog

IIHS: Drivers safer than passengers in frontal crash test

The Insurance Institute for Highway Safety introduced a small overlap frontal crash test in 2012 that replicates what happens when the front corner of a car impacts another object. In the test, vehicles travel at a speed of 40 mph toward a five-foot-tall barrier with 25 percent of the total width of the car striking the barrier on the driver side. One would assume that vehicles with good small overlap front ratings would protect the driver and the passenger equally. But a recent study from the IIHS proves that passengers aren't as protected as drivers. The IIHS conducted the test on seven small SUVs with good driver-side small overlap ratings and only one of the vehicles, the 2016 Hyundai Tucson, performed well enough to be given a good rating. The other SUVs performance ranged from poor to acceptable. After reviewing the results of the test, the IIHS is deliberating whether it should institute a passenger-side rating as part of its Top Safety Pick criteria. "This is an important aspect of occupant protection that needs more attention," states Becky Mueller, lead author of the study and an IIHS senior research engineer. "More than 1,600 right-front passengers died in frontal crashes in 2014." Since the small overlap front test was introduced, 13 automakers have made structural changes to 97 vehicles with roughly three-quarters earning a good rating after the adjustments. The IIHS' test for frontal ratings is completed with a dummy in the driver's seat and with a barrier overlapping the driver's side. Which makes sense, as passengers aren't always riding in a vehicle. "It's not surprising that automakers would focus their initial efforts to improve small overlap protection on the side of the vehicle that we conduct the tests on," states David Zuby, IIHS executive vice president and chief research officer. "In fact, we encouraged them to do that in the short term if it mean they could quickly make driver-side improvements to more vehicles. As time goes by, though, we would hope they ensure similar levels of protection on both sides." As the IIHS' test revealed, there's a massive difference in safety between the two front seats. Increase passenger safety, according to Mueller, would require automakers to strengthen the occupant compartment by using a different type of material or by making it thicker.

How Toyota's 100-year textile history influenced FCV hydrogen fuel cell car

Turns out, Toyota had a surprising ace in the hole when it came to building the new fuel tanks for the FCV hydrogen fuel cell car, which is coming next year. Well before Toyota became the Toyota Motor Company, it was the Toyota Industries Corporation and it made textile looms. This is important because the main structure of the hydrogen tank is wound carbon fiber. When Toyota set out to increase the strength of the tanks to hold hydrogen stored at 10,000 psi (up from 5,000 in the previous tanks), it was able to draw on its 100-year-old history as it designed its car of the future. "A lot of that textile experience came back when we did the tank wrapping." – Justin Ward "We have a lot of experience with textiles," Justin Ward told AutoblogGreen at the 21st World Congress on Intelligent Transport Systems (ITS) in Detroit this week, "and a lot of that textile experience came back when we did the tank wrapping." On top of being able to hold the higher-pressure hydrogen, Toyota's first attempt to build its own hydrogen tank was six times faster than the industry standard, so it saved time and money as well as working better. The company will also be able to inspect its own tanks. Ward is the general manager of powertrain system control at the Toyota Technical Center and hydrogen vehicles are something he knows a lot about. The reason for the stronger, 10,000-psi tanks is because the 5,000-psi tanks only offered around 180-200 miles of range, even with four tanks in the early $129,000 FCHV Highlander hydrogen prototypes. The FCV only has two, but they will able to deliver the 300-mile range that customers told Toyota they wanted. Dropping the number of tanks not only obviously reduced the cost for the tanks themselves but also the number of valves and hoses and other components you need. Despite the benefits of higher compression, going much higher doesn't make sense. 10,000 psi is the "natural progression," Ward said, because "you start to bump up against compression inefficiencies." Think of an air compressor. When hydrogen is produced at a wastewater treatment plant or a reforming site, Ward said, is it at around ambient pressure (14 psi). That has to be raised, using compressors, all the way to 10,000 psi. "That takes energy," Ward said, "and every doubling of pressure adds another doubling of energy needed, so it starts to add up pretty fast if you go too high." Component specifications are also fine at 10,00 psi, but more difficult at higher levels.

Subprime financing on the rise in new car sales, leasing too

We all remember the financial crisis that began several years back. At its core was a splurge of subprime lending for housing loans. The housing bubble burst, triggering a collapse of the mortgage-backed securities market. Apparently, those types of loans still exist in the automotive industry, and the market share for these types of "nonprime, subprime, and deep subprime," loans has grown 13.6 percent compared to the third quarter a year ago.
According to an Automotive News report, high-risk lending expanded to 24.8 percent of total loans in Q3, up from 21.9 percent for this time last year. As this level increased, average credit scores of borrowers dropped to 755, down from 763 a year ago. In that time, the average financing amount increased $90 per vehicle, to $25,963.
At 818, Volvo maintains the highest per-owner credit score, while Mitsubishi has the lowest, at 694. The highest rate of borrowers was at Toyota, with 14 percent of the market, followed by Ford with 13.1 percent and Chevrolet at 11.1.