1964 Gto, Tri-power, 4speed on 2040-cars

Auto blog

GM knew about fatal Chevy ignition problem decade before recall

Well, this is not good for General Motors. Following a report last week that GM was recalling 778,000 Chevrolet Cobalt and Pontiac G5 compacts over concerns that the ignition could switch out of the "run" position without warning, USA Today reports that the Detroit-based behemoth knew about the issue, which affected 2005 to 2007 Cobalts (the Cobalt shown above and in the gallery is from 2010) and 2007 Pontiac G5s, all the way back in 2004.
The information comes from a deposition in a civil lawsuit against GM, obtained by USA Today, which claims that a GM engineer experienced the issue while the then-new model was undergoing testing. The issue was "solved" when a technical service bulletin was issued in 2005, informing dealers to install a snap-on key cover on the cars of customers who complained about the issue. According to the Cobalt's program engineering manager, Gary Altman, the cover was an "improvement, it was not a fix to the issue."
The case where the depositions were made was from 2010, and involved Brooke Melton, a 29-year-old pediatric nurse in Georgia who was killed on her birthday. At the time, police claimed she was going too fast on a wet, rural road, although it later came out through the black box that her car's ignition had come out of the "run" position at least three seconds before the accident (the max amount of time a black box records before a wreck), disabling her airbags, power steering and anti-lock brakes. According to USA Today, police said Melton was "traveling too fast for the roadway conditions," although it's impossible to know if she'd have been in the wreck, which injured the occupants of another vehicle, had her 2005 Chevy not shut off. GM settled the Melton family's case, although the details remain confidential.

Junkyard Gem: 1986 Pontiac Fiero GT

If you like affordable, mid-engined two-seaters, the 1980s were your decade. Fiat (and, a bit later, Bertone) offered the X1/9, Toyota sold MR2s, and even General Motors got into the act by creating the Fiero. Available from the 1984 through 1988 model years, the Pontiac Fiero showed plenty of promise but ended up being mostly disappointing, in some ways echoing the career of the Chevy Corvair of a couple of decades earlier. Today's Junkyard Gem is a once-spiffy 1986 Fiero GT, found in a self-service yard near Denver, Colorado. After a long and painful development period stretching all the way back to John DeLorean's XP-833 Banshee (which ended up being a major influence behind the original Opel GT), the Fiero finally debuted in 1983 as a 1984 model. The top-of-the-model-range GT appeared the following year. The Fiero was built as a notchback coupe and as a fastback, with all the GTs being the latter type. I couldn't get the engine lid open, but this car would have left the assembly line (in Pontiac, Michigan) with a 2.8-liter V6 rated at 140 horsepower. This car has a five-speed manual transmission, making it a credible rival for Toyota's MR2.  The 1986 MR2 was less powerful than the Fiero GT (112 horsepower versus 140), but also scaled in significantly lighter (2,459 pounds against the Pontiac's 2,780 pounds). The MR2 also cost less, priced at $11,298 while the Fiero GT cost $12,875 (that's about $30,540 and $34,805, respectively, in inflation-adjusted 2022 dollars). Meanwhile, the $6,998 Honda Civic CRX two-seater lured away many potential Fiero buyers despite being a front-engined/front-wheel-drive car, and the $7,186 Ford EXP/Mercury LN7 also put a dent in Fiero sales. I can't find a price for the 1986 Bertone X1/9, but it cost a hard-to-believe $13,990 in 1984. GM still was using five-digit odometers in many vehicles by the middle 1980s, but this Fiero has a six-digit unit and thus we can see that it nearly achieved 150,000 miles during its driving career. The 1984-1987 Fiero suffered from a parts-bin suspension design, with the front suspension borrowed from the Chevrolet Chevette and the entire rear transaxle/suspension assembly lifted from the front end of the Chevrolet Citation. For the 1988 model year, GM finally spent the money to design an improved Fiero-specific suspension … and then promptly put a halt to production.

Lutz says GM was working on 5th-gen Pontiac GTO

Bob Lutz was one of the forces behind bringing the Holden Monaro to the United States, as the ill-fated Pontiac GTO in 2004. And while that car received critical acclaim, it was a sales disappointment. Now, Road & Track is reporting that our suspicions were correct - Pontiac was working on a two-door, G8-based coupe before it was shuttered.
In that R&T article, which is no longer available online, Lutz explained that the new GTO would solve many of the issues found in the original. Car Advice speculates that the new model would have look like a rebadged version of the Holden Coupe 60 Concept from 2008, a conclusion we also came to.
That car would have been a big departure from the 2004 to 2006 GTO. It has an extremely long hood and short rear deck, with an almost fastback roofline and a wide greenhouse with a tall beltline. The wheel arches were very pronounced, and the chin and rocker panel splitters gave it a race-ready look. Would it have been enough to make the GTO work in the US? We think it might of, but it looks like we'll never know.