1988 Fiero Gt Coupe, Nice Condition! Low Miles! Vintage Pontiac! Great Mileage on 2040-cars

Auto blog

Junkyard Gem: 1986 Pontiac Fiero GT

If you like affordable, mid-engined two-seaters, the 1980s were your decade. Fiat (and, a bit later, Bertone) offered the X1/9, Toyota sold MR2s, and even General Motors got into the act by creating the Fiero. Available from the 1984 through 1988 model years, the Pontiac Fiero showed plenty of promise but ended up being mostly disappointing, in some ways echoing the career of the Chevy Corvair of a couple of decades earlier. Today's Junkyard Gem is a once-spiffy 1986 Fiero GT, found in a self-service yard near Denver, Colorado. After a long and painful development period stretching all the way back to John DeLorean's XP-833 Banshee (which ended up being a major influence behind the original Opel GT), the Fiero finally debuted in 1983 as a 1984 model. The top-of-the-model-range GT appeared the following year. The Fiero was built as a notchback coupe and as a fastback, with all the GTs being the latter type. I couldn't get the engine lid open, but this car would have left the assembly line (in Pontiac, Michigan) with a 2.8-liter V6 rated at 140 horsepower. This car has a five-speed manual transmission, making it a credible rival for Toyota's MR2.  The 1986 MR2 was less powerful than the Fiero GT (112 horsepower versus 140), but also scaled in significantly lighter (2,459 pounds against the Pontiac's 2,780 pounds). The MR2 also cost less, priced at $11,298 while the Fiero GT cost $12,875 (that's about $30,540 and $34,805, respectively, in inflation-adjusted 2022 dollars). Meanwhile, the $6,998 Honda Civic CRX two-seater lured away many potential Fiero buyers despite being a front-engined/front-wheel-drive car, and the $7,186 Ford EXP/Mercury LN7 also put a dent in Fiero sales. I can't find a price for the 1986 Bertone X1/9, but it cost a hard-to-believe $13,990 in 1984. GM still was using five-digit odometers in many vehicles by the middle 1980s, but this Fiero has a six-digit unit and thus we can see that it nearly achieved 150,000 miles during its driving career. The 1984-1987 Fiero suffered from a parts-bin suspension design, with the front suspension borrowed from the Chevrolet Chevette and the entire rear transaxle/suspension assembly lifted from the front end of the Chevrolet Citation. For the 1988 model year, GM finally spent the money to design an improved Fiero-specific suspension … and then promptly put a halt to production.

Rumormill: DeLorean Motor Company considering rescuing Pontiac Solstice?

DeLorean Motor Company Pontiac Solstice renderings - Click above for high-res image gallery
General Motors has made a science out of sharing platforms. So when the company's Kappa platform was introduced for a new rear-drive roadster to be distributed across three different motor divisions, you'd have figured the program was pretty safe, right? Unfortunately for the workers at the Wilmington Assembly Plant which manufactured the Kappa roadsters, those three divisions were Pontiac, Saturn and Opel - three units which the General has either sold or shut down. Which is a shame, because a perfectly good rear-drive roadster platform is a heck of a thing to waste.
In one of the strangest rumors we've heard recently, however, our compatriots over at Jalopnik report that the DeLorean Motor Company (yes, that DeLorean Motor Company) is considering buying the plant and the platform from GM and putting it back into production as a new DMC.

This or That: 2005 Chrysler Crossfire SRT6 vs. 1984 Pontiac Fiero

Welcome to another round of This or That, where two Autoblog editors pick a topic, pick a side and pull no punches. Last round pitted yours truly against Associate Editor Brandon Turkus, and my chosen VW Vanagon Syncro narrowly defeated Brandon's 1987 Land Rover. In fact, it was, by far, the closest round we've seen, with 1,907 voters seeing things my way (for 50.8 percent of the vote) versus 1,848 votes for Brandon's Rover (49.2 percent). Sweet, sweet victory! For this latest round of This or That, I've roped Editor Greg Migliore into what I think is a rather fun debate. We've each chosen our favorite terrible cars, setting a price limit of $10,000 to make sure neither of us went too crazy with our automotive atrocities. I think we've both chosen terribly... and I mean that in the best way possible. 2005 Chrysler Crossfire SRT6 Jeremy Korzeniewski: Why It's Terrible: Taken in isolation, the Chrysler Crossfire isn't necessarily a terrible car. In fact, it drives pretty darn well, and there's a lot of solid engineering under its slinky shape. Problem is, that engineering was already rather long in the tooth well before Chrysler ever got its hands on it, having come from Mercedes-Benz, which used the basic chassis and drivetrain in a previous version of its SLK coupe and roadster. Granted, the SLK was an okay car, too, but even when new, it hardly set the world on fire with sporty driving dynamics. Chrysler took these decent-but-no-more bits and pieces from the Mercedes parts bin – remember, this car was conceived in the disastrous Merger Of Equals days – and covered them with a rather attractive hard-candy shell. Unfortunately, the super sporty shape wrote checks in the minds of buyers that its well-worn mechanicals were simply unable to cash, though an injection of power courtesy of a supercharged V6 engine in the SRT6 model, as seen here, certainly helped ease some of those woes. In the end, Chrysler was left with a so-called halo car that looked the part but never quite performed the part. It was almost universally panned by critics as an overpriced parts-bin special, which, I must add, was damningly accurate. As a result, sales were very slow, and within the first few months, dealers were clearancing the car at cut-rate prices, just to keep them from taking up too much of the showroom floor. Why It's Not That Terrible, After All: I can speak from personal experience when discussing the Chrysler Crossfire. You see, I owned one. Well, sort of...