1997 Lexus Sc 400 on 2040-cars

Auto blog

Lexus will bring production UX small crossover to Geneva

Lexus has announced it will show its upcoming UX crossover at the Geneva Motor Show next month. The new nameplate goes 0n a smallish crossover, designed to compete with the BMW X2, the Jaguar E-Pace, the Mercedes-Benz GLA and others. Some reports say the UX would be replacing the CT200h hatchback, which has been on the market since 2011. The manufacturer first used the name on a concept at the 2016 Paris Motor Show, and the shapes have now been worked into a production version. The Paris concept was certainly bulky and scifi-like, but then again, so is the Toyota C-HR on which the UX is reportedly based. Lexus trademarked the model names UX 200, UX 250 and UX 250h with the U.S. Patent and Trademark office way back in 2016, so expect those to reflect the powerplants on offer; the 250h stands for a hybrid version, as has become the norm. The UX's production version might also bear a similarly over-the-top spindle grille as on the LF-1 Limitless concept, which will also be shown at Geneva for its European premiere. The teaser image released by Lexus shows little more than a full-width taillight panel that takes a curious upturn at each end, and much of the crossover is still veiled by darkness. We'll see if any more teasers surface before the car's debut. View 17 Photos Related Video: Image Credit: Lexus Design/Style Geneva Motor Show Lexus Crossover Luxury 2018 Geneva Motor Show lexus ux lexus lf-1 limitless lexus ux concept

Why is there a huge bulge in 2021 Lexus IS 300 AWD's driver footwell? We explain

After an initial turn a few weeks ago for the 2021 Lexus IS first drive review, the revised luxury sedan has returned to the Autoblog garage for a second look. This middle-of-the-road IS 300 AWD pairs a 260-horsepower V6 with a six-speed automatic transmission and four driven wheels, and frankly it's the least interesting way to spec out the redesigned sedan. While there are cars in this segment designed to get a performance boost from their all-wheel-drive systems even in dry conditions, the IS isn't one of them. Adding insult to injury, you get stuck with a cramped driver-side footwell care of the engineering shenanigans that went into making this system possible.  While we've mentioned this particular compromise before, we rarely touch on the reasons why it exists in the first place. The fundamentals are fairly obvious; the standard IS utilizes a longitudinal, rear-wheel-drive powertrain. As is typical with this configuration, the transmission sits in a tunnel beneath the center console. This arrangement works just fine, provided you don't need to power the front wheels.  To do so in a traditional car like the IS requires a literal end-around maneuver involving the engine and transmission, which we've diagrammed for you below care of MSPaint. This is a bit simplified for the sake of this write-up, and it should be noted that this is not the only way to implement AWD in an inherently RWD platform, but it illustrates how the power for the front axle (red) and rear axle (blue) flows from the transmission to the drive wheels. To get juice flowing to the front axle, Lexus had to add a parallel output shaft, exiting the transmission from the front with enough clearance for the bell housing and engine, which sits between the transmission and the front differential. This requires quite a bit of lateral reach, meaning the housing has to extend much farther out than usual to accommodate it (yellow arrow). As a result, the all-wheel-drive transmission looks a lot like a sci-fi gun with a chunky drum magazine hanging off the side of it. The hump (above right) in the footwell is there to clear this protrusion. This basic configuration isn't unique to Lexus. In fact, if you look at a BMW xDrive cutaway, it's similar. So, why no "hump" in other cars? There are multiple factors, but to boil it down to what is most relevant, it's a combination of the resulting shape of the Lexus transmission housing and the size of the IS chassis.

Lexus LFA owner gets town to remove speed bump

What do you do if you have enough money to buy a Lexus LFA but can't get the car safely to your house? Get local government involved, of course. Rune Berge Vik, of Stavanger, Norway, did just that after he bought a Lexus LFA (the only LFA in the Nordic region according to tv2.no) last year only to find out that it could not clear a speed bump in his neighborhood.
To remedy the situation, Vik got in touch with his city, which had the speed bump removed. Talk about your tax dollars hard at work. On the other hand, it's commendable that the man actually uses his supercar as a daily driver, and besides, doesn't a street-legal car have the right to access said public streets?