2005 Infiniti Fx35 Damaged Clean Title Only 54k Miles Loaded Export Welcome!! on 2040-cars

Auto blog

Final Recap: Days 2 and 3 notes, quotes, and takeaways from the US Grand Prix

The Texas grass no longer rustles with 2.4-liter V8 exhaust blown at 18,000 revs, the Texas dust is no longer raised by hard-compound Pirellis. We saw a lot and learned a lot while we were there as guests of Infiniti, and after our Day 1 and race recaps, here are the bits left over from our time spent with the carmaker and Red Bull Racing, including thoughts on a "wicked" race, Christian Horner's quest for a more level playing field, Infiniti "going longer and deeper," and why Mario Andretti should get a police escort at the beginning of a race but not a microphone at the end...

Infiniti Q50 Eau Rouge Concept bows again, now with more GT-R [w/video]

Think back to the 2014 Detroit Auto Show and you'll remember the Infiniti Q50 Eau Rouge concept - a sedan that showed the potential design direction for a seriously high-performance take on the Japanese automaker's new entry-level luxury sedan. And while the show car we saw in Detroit was all well and good, it lacked something. Specifically, an engine. Kind of an important thing for a performance concept, right?
Here in Geneva, Infiniti rolled out that same Q50 Eau Rouge, but with one major modification: the sedan now boasts a twin-turbocharged 3.8-liter V6 under its hood - the same engine that's found in the Nissan GT-R supercar. In the Eau Rouge, this V6 is tuned to produce 560 horsepower and 443 pound-feet of torque, sent to the ground via the GT-R's all-wheel-drive system. Of course, this super-hot Q50 is still purely a concept, but Infiniti says that the potent engine underhood will allow the sedan to sprint to 60 miles per hour in less than four seconds, on its way to a top speed of over 180 mph.
The oft-fabled "four-door GT-R" still isn't confirmed for production, so for now, all we can do is cross our fingers (and toes). Check out the Q50 and its new beating heart in the gallery, above, and scroll below to hear what that potent Eau Rouge sounds like.

Infiniti Prototype 9 is a wonderfully beautiful EV grand prix car

Few automobiles are as elegantly beautiful as the open-wheel grand prix cars of the 1940s, '50s and '60s. The simple, slender shapes of these cars bear no extravagant flourishes or adornments. The purposeful design is what gave these cars their beauty, and it's these classic machines that inspired the new Infiniti Prototype 9. Teased earlier this week, this concept blends old and new, with classic lines hiding a modern all-electric powertrain. The Prototype 9 will make its full debut next week at the 2017 Pebble Beach Concours d'Elegance. Infiniti says the car was built around a simple idea: what would a 1940s Infiniti grand prix car look like? While the silver paint may be more German than Japanese, the design could easily be mistaken for an actual '40s grand prix car. Only the Infiniti-styled grille gives it away. Everything about it, from the thin bias-ply tires wrapped over center-locking wire wheels to the bulging screws around the driver's seat, is pitch perfect. Underneath that achingly long hood rests a prototype electric motor and battery from Nissan's Advanced Powertrain Department. The combo sends 148 horsepower and 236 pound-feet of torque straight to the rear wheels. That's good enough to send the svelte 1,962 lb car to 62 mph in just 5.5 seconds. Top speed is right at 106 mph. While speed may die off towards the top end, all that torque and a 43/57 front to rear weight distribution should make the Prototype 9 a riot on a small, tight circuit. There's only enough juice in the battery for about 20 minutes of flat-out racing. The handmade steel body rests on a steel ladder-frame chassis. The front suspension uses a leading-arm rigid axle with transverse leaf spring while the rear uses a De Dion axle, also with a transverse leaf spring. The Prototype 9 also uses old-school hydraulic rotary type dampers. There's no power steering and no brake booster for the four-wheel disc brakes. The car was designed and built by a number of different departments within Infiniti and Nissan. A simple sketch expanded as more and more designers and engineers wanted to have a hand in the project. The steel body panels were all shaped and hammered by hand. The bare cockpit is only adorned with a thin seat, three gauges, a few switches, a gear selector and the steering wheel. The gauges are set into a fixed aluminum hub in the center of the steering wheel.