2014 Hyundai Sonata Limited on 2040-cars

Auto blog

Hyundai recalls 43k Genesis and Equus models for faulty lighting

As you can imagine, it'd be a bit of a problem if the brake lights on your car didn't work. And that, unfortunately, is precisely the problem that Hyundai has found with some of its higher-end offerings, prompting the Korean automaker to issue a recall. (One of a great many recalls issued by the National Highway Traffic Safety Administration today, as you can no doubt see.) The problem apparently revolves around a failure in the circuit that's supposed to illuminate the taillights when the driver hits the brakes. If that doesn't work, of course, the vehicle behind would be more likely to crash into the Hyundai in question. As a result, Hyundai is recalling precisely 42,925 units, split between the 2009-2011 Genesis (manufactured between April 30, 2008, and November 21, 2010) and the 2011 Equus (manufactured between July 31, 2010 and November 21, 2010). Owners of those vehicles will be notified to bring their vehicles in to have their brake light circuits repaired. RECALL Subject : Inoperative Stop Lamps Report Receipt Date: NOV 07, 2014 NHTSA Campaign Number: 14V713000 Component(s): EXTERIOR LIGHTING Potential Number of Units Affected: 42,925 Manufacturer: Hyundai Motor America SUMMARY: Hyundai Motor America (Hyundai) is recalling certain 2009-2011 Hyundai Genesis vehicles manufactured April 30, 2008, to November 21, 2010, and 2011 Hyundai Equus vehicles manufactured July 31, 2010, to November 21, 2010. Due to a circuit failure, the stop lamps in the affected vehicles may not illuminate. CONSEQUENCE: A following vehicle may not recognize that the vehicle is slowing or coming to a stop if the stop lamps on the vehicle do not illuminate as expected. There is an increased risk of a rear-end crash as a result. REMEDY: Hyundai will notify owners, and dealers will repair the stop lamp switch circuit, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Hyundai customer service at 1-714-865-3920. Hyundai's number for this recall is 125. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

We check out Hyundai's HRL exoskeleton, a robotic mobility suit for paraplegics

Hyundai makes some of the largest vehicles in the world – to wit, 185,000-ton ships with 56-foot high engines making power at 84 rpm – but its R&D division has found enough human-factor synergy with autonomous vehicle development that they're now working on robotic exoskeletons. We were recently introduced to two of these devices: the HRL designed to increase mobility and therefore quality of life for paraplegics; and the WEX, designed to assist in repetitive-motion lifting. Both of these machines are powered by replaceable lithium-ion battery packs with a 4-hour run time and 40-minute recharges. The HRL robotic legs are designed for people 64 to 71 inches tall and less than 250 pounds. The aluminum segments are adjustable in centimeter increments over a 10-cm range, and the 22.4-inch width means it would fit in many long-haul aircraft forward seats. With the 4.4-lb battery pack, the HRL weighs about 41 pounds. There are six 50:1 reduction-gear actuators, two pelvic actuators rated at 224 pound-feet of peak torque with 60-degree range of motion, and two hip and knee with 112 lb-ft peak, 180 degrees and twice the rotational speed of the pelvic motors. Twenty sensors control it all with default speed of just under a mile per hour and a top speed of 1.5 mph, and step length can be adjusted by smartphone via Bluetooth. One of the accompanying crutches has four thumb buttons much like a video-game controller, though they're experimenting with simpler inputs including a joystick. The crutch communicates with the leg unit over a few feet of distance via Zigbee wireless protocol, with security layers added for both obvious reasons and to ensure two users in the same vicinity won't transmit to the other's unit. An HRL can help you sit, stand, walk or climb and descend stairs; it will also stand on its own, simplifying the process of putting it on. Your correspondent is outside the design height limits so rather than do any impromptu CG research we deferred to colleague Chris Davies of Slashgear for impressions wearing it: "It grips tightly, the support would be comforting, and it delivers good posture. It does take some getting used to – when it first lifts up a leg to move it forward you do feel like you're going to fall over – but once you establish a gait and stop over-thinking it becomes much easier." Indeed, he never fell over and most who tried established a rhythm within a few minutes, if not a 1.5-mph sprint.

Porsche purists, look away: This 911 is powered by Hyundai

Bisimoto appears to be putting together a Hyundai V6-powered Porsche 911. While the experiment reminds us of a project from earlier this year, in which Ryan Tuerck dropped a Ferrari V8 into Toyota GT86, this one's a bit different. Bisimoto has a history of creating some truly insane automobiles, usually with Veyron-menacing power levels. In fact, the tuning company built multiple 1,000 horsepower machines, including a 1976 Porsche 911 and a 2013 Hyundai Genesis Coupe, not to mention a few other Hyundais with oodles of power. So it seems Bisimoto has decided to combine the company's experience with both marque's into one machine with this 1977 Porsche 911. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. The company revealed the intended engine for the car today, next to the disassembled tail end of the 911. No specific details about the engine were given, but a "hyundaiusa" tag, some helpful hints from Instagram commenters and some diligent Google image searching by Autoblog staff members seem to show that this is a Hyundai Lambda series V6. It also appears to be a version from a car with a transverse layout, which would make it easier to fit in the 911's traditional engine location. What we do know is that the build will be completed in time for the SEMA show, and we look forward to seeing the finished Franken-Porsche. The same probably can't be said for Porsche purists though. Related Video: News Source: Bisimoto EngineeringImage Credit: Bisimoto Engineering Auto News SEMA Show Hyundai Porsche tuning engine swap bisimoto