2024 Gmc Sierra 1500 Denali Ultimate on 2040-cars

Auto blog

2014 Chevrolet Silverado and GMC Sierra debut all-new designs, three new engines

General Motors has finally dropped the curtain on the 2014 Chevrolet Silverado and 2014 GMC Sierra. Both trucks have undergone substantial revisions with updated versions of the company's 4.3-liter V6, 5.3-liter V8 and 6.2-liter V8 engines. In a shot across the bows of both Ford and Chrysler, GM says it won't use a V6 engine adapted from passenger car applications. Instead, it developed the 4.3-liter engine based on its proven truck-duty architecture.
All three mills will boast direct injection fuel systems as well as a new cylinder head design. Combined with a revised piston, the new engines feature a smaller combustion chamber with a compression ratio of 11:1 or higher depending on the application. Cylinder deactivation and continuously variable valve timing are all part of the recipe, and each engine is paired with a six-speed automatic transmission with auto grade breaking. So far, no fuel economy or horsepower figures have been released, though GM says the new engines will best their predecessors in both areas.
Outside, the trucks feature a number of enhancements to reduce drag and wind noise, and GM claims both the Silverado and Sierra will offer buyers some of the quietest cabins in the class. Extended cab models now feature front-hinged rear doors to allow easier access to the back passenger area, and Crew Cab buyers can now select between a five-foot, eight-inch bed or a six-foot, six-inch bed. Buyers with a mind toward going off road will also rejoice in the return of the Z71 package, complete with Rancho shocks, front tow hooks and additional under-body protection.

GM recalls Chevy Express, GMC Savana over rollaway concern

The National Highway Traffic Safety Administration has issued a recall notice for a small number of General Motors fullsize vans due to possible rollaway concerns. On certain 2013 Chevrolet Express and 2013 GMC Savana models, it is possible to remove the key from the ignition without the shifter being in park.
Only 980 total units are being affected by this recall, and GM is fixing the issue by replacing the ignition cylinder and associated keys. Affected Chevy vans were built during most of November and December while its GMC counterpart was only built for a week in November. The recall goes into effect on January 23, and to find out if your vehicle applies to the recall, the GM and NHTSA contact numbers can be found on the official recall notice, which is posted below.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck