2001 Ford Ranger Xlt Extended Cab Pickup 2-door 3.0l on 2040-cars

Auto blog

Ford EcoBoost V6 hits the dyno before hitting the track

Ford Racing just unveiled the Riley Daytona Prototype that will make its racing in the United SportsCar Racing Championship Rolex 24 at Daytona in January, and now it has released a video showing development of twin-turbo 3.5-liter EcoBoost V6 that powers the car. Using the same block and heads that can be found on a production Ford Taurus SHO, this new racecar benefits from the collaboration between Ford Racing and Ford powertrain engineers.
While we still don't know what kind of power this engine is putting out, it has definitely gotten a workout at Ford's 17G dyno. This area deep within Ford allows the automaker's racing program to work hand-in-hand with production engine programs, which can be a benefit to racing operations and production cars alike. Scroll down to hear a few people from Ford talk about the crosspollination between its racing and engine teams and watch the EcoBoost get red hot on the dyno.

GM also sheds parts from its pickups to boost payload ratings

The row between Ford and Ram over who boasts the best-in-class tow rating for heavy duty pickups has revealed a number of things. Chief among them is a report that Ford removes items like the spare tire, jack, radio and center console from its vehicles in a bid to lower its base curb weight and therefore keep the truck's gross vehicle weight rating down.
For those that need a refresher, GVWR is the vehicle's curb weight plus its maximum payload. A lower GVWR allows Ford to station its F-450 among the so-called Class III pickups, despite the fact that internally, it has the makings of a more brutish Class IV truck.
Ford explains away these deletions, saying a customer could order their vehicle in such a manner. It has also come to light that Ford is not the only automaker to engage in such practices.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.