1928 Model A Ford Fourdoor Leatherback. on 2040-cars
Floresville, Texas, United States
Fuel Type:Gasoline
Engine:4 cylinder gas
For Sale By:Private Seller
Mileage: 2,331
Model: Model A
Trim: standard
Drive Type: 2 wheel
Year: 1928
Ford Model A for Sale
Ford model aa, flatbed truck, classic cab, great driver, rust free(US $15,000.00)
1929 model a tutor in very good looking and driving condition. new tires.(US $10,000.00)
1931 ford tudor,ratrod
1920's ford model a cab only, great patina, rat rod, hot rod, no reserve
1931 ford model a coupe hot rod rat rod hotrod ratrod 1930 custom
1930 ford model a roadster
Auto Services in Texas
Woodway Car Center ★★★★★
Woods Paint & Body ★★★★★
Wilson Paint & Body Shop ★★★★★
WHITAKERS Auto Body & Paint ★★★★★
Westerly Tire & Automotive Inc ★★★★★
VIP Engine Installation ★★★★★
Auto blog
Ford trademarking 'Mach 1,' possibly for Mustang
Thu, 24 Oct 2013A legendary name might be accompanying the redesigned, 2015 Mustang when it finally makes its world debut - Mach 1. Stumbled upon by the team at Ford Authority, the Mach 1 title was found in a trademark filing with the US Patent and Trademark Office, and would revive a name last used on the fourth-generation, 2003 Mustang.
While the the 2003 vintage was well and good, the Mach 1 is really remembered for a three-year run from 1969 to 1971 - it's best to just forget the emissions-choked 1972 to 1978 Mach 1s - when power output ranged from a modest 250 horsepower with the two-barrel, 351-cubic-inch Windsor V8 to "375 hp" (actual output was rumored to be well north of 400 horsepower) with the righteous, 429-cubic-inch Super Cobra Jet V8.
What does the title hold for the sixth-generation Mustang? It's tough to say. The fanatics at Ford Authority seem to think Mach 1 could take the place of the Shelby GT500 at the top of the Mustang hierarchy, which sounds like a valid argument. At the same time, we could see the SVT Cobra moniker returning for the flagship model, and the Mach 1 doing battle with the Chevrolet Camaro Z/28 (unless the Boss 302 were to return). Confounding things is the historical precedent - the Mach 1 was responsible for the death of the Mustang GT in 1969, so it might make sense as a volume performance model.
Ford recalls more than 550,000 trucks and SUVs for various safety issues
Wed, Aug 12 2020Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power. The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts. The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic. Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact. The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.
Barrett-Jackson 2014: First production 2015 Ford Mustang earns $300k for JDRF [w/video]
Sat, 18 Jan 2014We've almost become immune to the huge dollar amounts that collectible cars earn for charity at Barrett-Jackson. To wit, $300,000 for the first production 2015 Ford Mustang initially didn't seem like very much money. In reality, though, it's probably about 10 times the actual asking price for the car, and we're pleased to report that 100 percent of the proceeds will go to the Juvenile Diabetes Research Foundation.
According to Ford, the car's winning bidder will get to "choose a fastback with manual or automatic transmission, and any interior, exterior and stripe color combination offered by Ford on the all-new Mustang." Power will come from a slightly revised version of the well-known 5.0-liter V8 engine that will produce "more than 420hp and 396 pound-feet of torque."
We snapped live images of the 2015 Mustang prototype that Ford had on display here at Barrett-Jackson, and you can check them out above. The official auction description, along with a video of the auction as it happened live, is below.



