2004(04) Ford Focus Zts Power Windows & Locks! Clean! Save Huge! Must See!!! on 2040-cars

Auto blog

VW going turbo-only in 3 to 4 years

This really was a matter of when, rather than if. Volkswagen will apparently be the first manufacturer to phase out naturally aspirated engines in favor of turbocharging its full slate. VW is kind of responsible for ushering in this push towards small-displacement, turbocharged engines that's taken the industry by storm. When it dropped its direct-injection, 2.0-liter turbo in the 2005 GTI it demonstrated that strapping an iron long to an engine can enhance the powertrain as a whole. VW made fuel economy gains, while also giving a linear, non-laggy turbo experience that it has replicated, model-after-model, to this day.
Speaking with The Detroit News, Volkswagen's executive Vice President of Group Quality, Marc Trahan, told the paper that, "We only have one normally aspirated gas engine, and when we go to the next generation vehicle that it's in, it will be replaced. So three, four years maximum."
Really, it's hard to get teary-eyed about either of these engines going away. VW has access to smaller powerplants that could easily match the performance of the 2.5 five-cylinder and the 3.6 V6, while gobbling up less fuel and providing a better driving experience. What we are sad about is that a similar statement about the extinction of NA engines came from the Vice President of Powertrain Engineering at Ford, Joe Bakaj. We'd certainly get teary-eyed over a world without Ford's excellent 5.0-liter V8.

Report: GM struggling to market turbo technology

In the automotive realm, marketing can sometimes prove just as important as the actual product. Take, for instance, Ford's well regarded EcoBoost technology, which couples turbocharging with direct injection to produce more horsepower and reduce fuel consumption. Would it surprise you to hear that General Motors has had similar technology on the market for over three years?
It's true. GM's first turbocharged, direct injected powerplants hit the market for the 2007 model. The 2.0-liter Ecotec mills put down an impressive 260 horsepower and a matching 260 pound-feet of torque, and they were lauded by the press in the engine bays of the Pontiac Solstice, Saturn Sky, Chevrolet Cobalt SS and Chevrolet HHR SS. But few people outside a core group of enthusiasts actually remember this fact.
Says Uwe Grebe, executive director of GM's global advanced engineering, "We didn't have a badge and say, 'This is the most important thing we will put on all our brochures.'" Ford, however, did just that, and it's EcoBoost engines are right at the tips of all our tongues when we discuss today's most advanced powerplants. So, how does The General fix its mistake?

Ford dealers offered discounts on tools to fix aluminum

With the introduction of the aluminum-bodied 2015 Ford F-150 (and the likely use of aluminum in future Ford products), Ford is looking to help its dealerships reduce costs related to repairing this more labor-intensive material. Automotive News is reporting that Ford dealers with body shops will require an estimated $30,000 to $50,000 in equipment and training to work on aluminum, and to help alleviate the financial burden of the new F-150, Ford has announced a special 20-percent discount on this equipment.
Dealers will be able to save up to $10,000 on tools such as welders, air-filtration systems and rivet guns and to create aluminum-specific work stations. The new F-150 goes on sale in the fourth quarter, and dealers have until October 31 to take advantage of this deal, according to the report.