Find or Sell Used Cars, Trucks, and SUVs in USA

1973 Ford Gran Torino Fastback 4 Speed Cobra Jet on 2040-cars

US $4,995.00
Year:1973 Mileage:99999 Color: Red /
 Black
Location:

Sewell, New Jersey, United States

Sewell, New Jersey, United States
Advertising:
Transmission:Manual
Body Type:Coupe
Vehicle Title:Clear
Engine:8
Fuel Type:Gasoline
For Sale By:Private Seller
Condition:
Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ...
VIN (Vehicle Identification Number)
: 12121212121212121
Year: 1973
Make: Ford
Model: Torino
Drive Type: RWD
Mileage: 99,999
Disability Equipped: No
Exterior Color: Red
Warranty: Vehicle does NOT have an existing warranty
Interior Color: Black
Trim: VINYL
Number of Cylinders: 8

 

ITS A RARE 1973 GRAN TORINO. FASTBACK  LASER STRIPE CAR WITH 351 CLEVELAND COBRA JET ENGINE    4 SPEED   ALL ORIGINAL CAR.

 

IT WAS INSIDE A BODY SHOP SINCE 1987.

 

 

THIS IS A RUNNING PROJECT THAT YOU COULD BE DRIVING IN A FEW DAYS AFTER STARTING THE WORK ON IT.

I WAS IN AN ACCIDENT AFTER I PURCHASED IT SO THE PROJECT HAS STALLED.

LOOK AT THE PICS, THE CAR IS AN AUTHENTIC FASTBACK, LASER STRIPE Q CODE 4 SPEED 351 RUNNING CLEVELAND COBRA JET ENGINE   ORIGINAL   POINT   WHICH IS EXTREMELY RARE AND IT RUNS GOOD TOO        . 9 INCH REAR TOO.

I STARTED FITTING SOME PANELS AND CUTTING OUT SOME BAD METAL. IT COMES WITH 2 GOOD REPAIRABLE FRONT FENDERS A GOOD EXTRA GRILL

A COMPLETELY RESTORED TRUNK LID JUST PUT ON. A NEW CLEAN RUST FREE HEADER A DASH PAD A NEW HEADLINER MISC MOLDINGS A BOX OF MISC PARTS.

WHAT IT NEEDS IS A HOOD FOUND 2 IN PHILLY WITH SCOOPS AND A REAR VALANCE DEARBORN MAG HAS IT IN FIBERGLASS FOR 199.00 AND FRONT SEAT COVERS 300.00 ALSO THE CENTER OF THE WHEEL PAD FOR THE STEERING WHEEL. ABOUT 125.00 ON EBAY.

OTHER THEN THOSE PARTS THE CAR IS ALL THERE

THE FAN AND SHROUD ARE OFF SO I COULD PAINT THE ENGINE AND COMPARTMENT

I HAVE FORD BLUE PAINT TO GO WITH IT. ALSO NEW PLUG WIRES TOO..

THIS IS AN EASY RESTORATION AND AGAIN A RARE CAR TO BE ALL INTACT AS IT IS.

THE D/S QUARTER NEEDS A PATCH I HAVE FRONT AND REAR BUMPERS THAT ARE GOOD AND CLEAN READY TO USE++++++++

THE PASS QUARTER IS NEW AND NEEDS TO BE FIT AND WELDED I HAVE IT HANGING ON THE SIDE.

THE TRUNK CENTER IS SOLID THE SIDES NEED TO BE PATCHED, I CUT THE BAD METAL OUT ALREADY SO YOU JUST NEED TO WELD THE PATCH PANELS IN AND MAKE A L/S SUPPORT.. THE FLOOR PANS LOOK GOOD SURFACE RUST ON FRAME BUT IT LOOKS ALL SOLID. ALL GLASS IS 100% ALL THE TRIM IS THERE NO RUST OR ROT AT ALL AROUND THE WINDOWS....... THATS RARE SO THE GLASS DOES NOT HAVE TO COME OUT......
THE WHEELS COULD BE CLEANED OR RECHROMED. NEEDS NEW TIRES

I HAVE HAD MANY OFFERS AND DIDNT REALLY WANT TO SELL IT BUT THE ACCIDENT TOOK ME OUT OF THE GAME FOR NOW.

CASH OR TRADES AS IM FLEXIBLE JUST WANT SOMEONE TO RESTORE IT.. ITS A GREAT FATHER SON PROJECT. SELLING IT CHEAP SO SOMEONE CAN AFFORD TO PUT IT TOGETHER PROPERLY....

 
THIS WAS AN UNTOUCHED UNMOLESTED CAR WITH 4 SPEED AND COBRA JET ENGINE

Auto Services in New Jersey

Zambrand Auto Repair Inc ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Automobile Inspection Stations & Services
Address: 250 42nd St, Bloomfield
Phone: (718) 965-1903

W J Auto Top & Interiors ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Automobile Seat Covers, Tops & Upholstery
Address: 2255 Wyandotte Rd Ste B, Pennsauken
Phone: (215) 659-5125

Vreeland Auto Body Co Inc ★★★★★

Automobile Body Repairing & Painting, Used Car Dealers, Automobile Repairing & Service-Equipment & Supplies
Address: 330 Vreeland Ave, Haskell
Phone: (973) 684-1382

Used Tire Center ★★★★★

Automobile Parts & Supplies, Tire Dealers
Address: 1070 Salem Rd, North-Plainfield
Phone: (908) 349-8027

Swartswood Service Station ★★★★★

Auto Repair & Service, Gas Stations
Address: 902 Swartswood Rd, Tranquility
Phone: (973) 383-4345

Sunrise Motors ★★★★★

New Car Dealers, Automobile & Truck Brokers
Address: 430 Industrial Ave Ste 11P, Ridgefield
Phone: (201) 462-9000

Auto blog

Rising aluminum costs cut into Ford's profit

Wed, Jan 24 2018

When Ford reports fourth-quarter results on Wednesday afternoon, it is expected to fret that rising metals costs have cut into profits, even as rivals say they have the problem under control. Aluminum prices have risen 20 percent in the last year and nearly 11 percent since Dec. 11. Steel prices have risen just over 9 percent in the last year. Ford uses more aluminum in its vehicles than its rivals. Aluminum is lighter but far more expensive than steel, closing at $2,229 per tonne on Tuesday. U.S. steel futures closed at $677 per ton (0.91 metric tonnes). Republican U.S. President Donald Trump's administration is weighing whether to impose tariffs on imported steel and aluminum, which could push prices even higher. Ford gave a disappointing earnings estimate for 2017 and 2018 last week, saying the higher costs for steel, aluminum and other metals, as well as currency volatility, could cost the company $1.6 billion in 2018. Ford shares took a dive after the announcement. Ford Chief Financial Officer Bob Shanks told analysts at a conference in Detroit last week that while the company benefited from low commodity prices in 2016, rising steel prices were now the main cause of higher costs, followed by aluminum. Shanks said the automaker at times relies on foreign currencies as a "natural hedge" for some commodities but those are now going in the opposite direction, so they are not working. A Ford spokesman added that the automaker also uses a mix of contracts, hedges and indexed buying. Industry analysts point to the spike in aluminum versus steel prices as a plausible reason for Ford's problems, especially since it uses far more of the expensive metal than other major automakers. "When you look at Ford in the context of the other automakers, aluminum drives a lot of their volume and I think that is the cause" of their rising costs, said Jeff Schuster, senior vice president of forecasting at auto consultancy LMC Automotive. Other major automakers say rising commodity costs are not much of a problem. At last week's Detroit auto show, Fiat Chrysler Automobiles NV's Chief Executive Officer Sergio Marchionne reiterated its earnings guidance for 2018 and held forth on a number of topics, but did not mention metals prices. General Motors Co gave a well-received profit outlook last week and did not mention the subject. "We view changes in raw material costs as something that is manageable," a GM spokesman said in an email.

Weekly Recap: Toyota, Mazda team up to 'make cars better'

Sat, May 16 2015

Toyota and Mazda are teaming for a noble purpose: to "make cars better." That's how the two Japanese automakers termed their partnership, which was announced this week. So what does this actually mean? The companies said they will set up a joint committee to look for areas of cooperation and named safety and the environment as issues they plan to tackle. From a product perspective, it's believed that Toyota is interested in Mazda's Skyactive engine portfolio. In turn, Mazda has its eye on Toyota's fuel-cell and plug-in hybrid technology. While more specifics were not confirmed, the companies said the "agreement will go beyond the traditional framework of cooperation," and it has the potential to be a long-range partnership. "The main purpose of this initiative is to enhance the appeal of our cars," Toyota president Akio Toyoda said at the announcement. Previously, Mazda has licensed Toyota's hybrid tech and assembled compact cars for Toyota in Mexico. Akio Toyoda said these projects "triggered" the automakers to explore further collaboration. Dave Sullivan, product analysis manager for AutoPacific, said the tie-up echoes Daimler's wide-ranging work with the Renault-Nissan alliance. "This could be a well-groomed match due to each having very unique skill sets," he said. OTHER NEWS & NOTES Volvo selects South Carolina for US factory Volvo confirmed this week that it will build its first US factory in South Carolina, with construction set to begin this fall. The company first revealed plans in March, though it didn't announce a site. The plant will have initial annual production of 100,000 units, though the vehicle or vehicles to be assembled were not specified. The factory, located near Charleston, will open in 2018 and ultimately employ 4,000 people. The facility will help Volvo continue its growth strategy, which includes strengthening its presence in the US market, where it wants to sell more than 100,000 cars per year. "Building a plant in the US is a reflection of Volvo Cars' commitment to the US and the key role the US plays in our growth objectives," Lex Kerssemakers, senior vice president, Americas, said in a statement. Ford GT spied on the road The 2017 Ford GT was spotted testing around the Blue Oval's headquarters in Dearborn, MI, this week. The raw body panels were exposed, and they lacked paint or camouflage. It's the first time the GT has been captured on the street after a spring of auto show reveals.

Former Ford president, Jaguar chairman Nick Scheele dead at 70

Sun, 20 Jul 2014

We have the privilege here at Autoblog of reporting a lot of good news, but it is our duty as well to report the bad news and sad news as well. And this is one of those occasions as the automotive industry mourns the passing of one of its leaders.
Nick Scheele was born in the UK in 1944 and joined the Ford Motor Company upon graduating from the University of Durham in 1966, staying within the Blue Oval's portfolio for the entirety of his career. After moving to North America in 1978, he rose through the ranks to become president of Ford's Mexican operations in 1988. After acquiring Jaguar, Ford appointed Scheele as its chairman.
Scheele subsequently acted as chairman of all of Ford's European operations, making difficult decisions to take the division out of the red and into the black. He briefly headed up Ford's North American division before he was appointed in 2001 as president and chief operating officer of the global automaker, working under CEO Bill Ford following the departure of Jacques Nasser departure and retaining the role until his retirement in 2005.