2015 Ford Taurus Sel on 2040-cars

Auto blog

XCAR stages epic drag race between Ford GT40, GT70 and GT

XCAR has put together what it believes is a first - a drag race between Ford's legendary, Le Mans-winning GT40, the more recent GT supercar it inspired and the little-known GT70 rally car. The three mid-engined monsters were all built for very different purposes, and not surprisingly, they come to battle with very different powertrains.
The GT40 is powered by a thumping, naturally aspirated V8. This example, which looks like a Mark IV model, is likely powered by a 7.0-liter engine, although it's not entirely clear how much power it's putting down. The GT70, meanwhile, was Ford's response to the Lancia Stratos. Considering that the Lancia is one of the greatest rally cars in history and many of you are probably just hearing of the GT70 for the first time, you can imagine how much success Ford had with it. Only six were produced before a change in regulations doomed this mid-engined rally car.
The Ford GT, meanwhile, doesn't really need an introduction. 550 horsepower is on offer from a 5.4-liter, supercharged V8, which keeps the GT competitive even against more modern supercars. 60 miles per hour arrives in well under four seconds while the top speed sits at 212 mph. Not bad for a car that went out of production in 2006.

2017-19 Ford Super Duty trucks recalled for tailgates that could open

Ford announced two separate recalls today, though neither has resulted in any known injuries. The first recall, which deals with a tailgate malfunction, affects 261,617 examples of 2017-2019 F-250, F-350, and F-450 Super Duty pickups. The second, which anticipates the possibility of a fuel leak, affects 3,893 units of 2020 Explorer and 2020 Lincoln Aviator SUVs with 3.0-liter engines. Ford says tailgates might accidentally open on some 2017-2019 Super Duty trucks because of a short circuit. If the pickups have an electric tailgate latch-release switch on the tailgate handle, water might get into the wiring. If the water hits the right spots, a short circuit could cause the switch to release the tailgate latch. In a worst-case scenario where the tailgate opens while driving, contents of the truck's bed could fall out and create a safety hazard. Dealerships will fix the problem by modifying the tailgate frame wiring harnesses with jumper pigtails and install a new tailgate handle release switch. Of the lot, 231,664 trucks are in the U.S., and 29,953 are in Canada. The Ford recall number is 19S48.  The second recall is much smaller, involving fewer than 4,000 vehicles. In certain 2020 Explorers and Aviators with 3.0-liter engines, Ford says, "The convolute protective sleeve on the liquid fuel line is not long enough, which may allow for potential hard contact with the convolute-protected vapor fuel line. Over time, with vibration and engine roll, hard contact between the two fuel lines could cause the convolute on the vapor fuel line to rub through the plastic liquid fuel line." If that happens, it could be a fire risk and hazardous for drivers and passengers. Only 35 of those SUVs are in Canada, and the rest are in the United States. Dealers will fix the problem by replacing the defective convolute with a full-length piece and tying it down with a strap. The recall reference number for the Aviators and Explorers is 19S49. The recall adds to what has otherwise been a rocky early production phase for the new Explorers and Aviators.

Detroit automakers keep their masks on to keep the factories running

United Auto Workers members leave the Fiat Chrysler Automobiles Warren Truck Plant in May. Fiat Chrysler along with rivals Ford and General Motors Co., restarted the assembly lines after several weeks of coronavirus lockdown. (AP)   DETROIT — When the coronavirus pandemic slammed the United States in March, the Detroit Three automakers shut their plants and brought their North American vehicle production to an unprecedented cold stop. Now, four months after a slow and sometimes bumpy restart in May, many General Motors, Ford and Fiat Chrysler Automobiles  factories are working at close to full speed, chasing a stronger-than-expected recovery in sales. So far, none of the Detroit Three has had a major COVID-19 outbreak since restarting production, even as the coronavirus is surging in Midwestern and Southern communities outside factory walls. "We have people testing positive, but it's not affecting operations," said Ford global manufacturing chief Gary Johnson. Keeping the pandemic at bay has pushed the automakers and 156,000 U.S. factory employees represented by the United Auto Workers into unfamiliar work routines and extraordinary levels of cooperation among the rival automakers that will have to be sustained for months to come. For automakers, the automakers' COVID response has been as much about instilling new habits as relying on new technology. Workers log their symptoms, or lack of them, into smartphone apps and walk past temperature scanners to get to their work stations. But company and union executives said masks, along with physical distancing, are the key to keeping assembly lines rolling. "The mask is the foundation" of protecting workers on the job, said Johnson. Complaints about masks Autoworkers are accustomed to wearing protective gear such as shatterproof glasses and gloves. Masks that cover the mouth and nose, however, were not standard equipment on auto assembly lines, and were a tough sell at first. "The biggest complaint is wearing a mask," United Auto Workers President Rory Gamble told Reuters. "A lot of our members perform physical tasks. Wearing the mask inhibits breathing." Beyond that, Gamble said, masks and distancing make it harder for workers to have conversations on the job or socialize during breaks. "ThatÂ’s pretty much out the window, and it makes for a longer day," he said. Masks make it harder for co-workers to read each other's expressions — often crucial in the noisy environment of a car plant.