2008 Dodge Ram 5.7l Hemi Only 39,026 Miles on 2040-cars

Auto blog

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

The Dodge Neon is alive!

"Holy crap! It's a new Dodge Neon! Like a new new one." Oddly, no one else on the Cancun resort shuttle seemed to notice. Or care. Ogling Mexican-market compact sedans is apparently something exclusive to automotive journalists on vacation. Yet there it was, fittingly on Dio de los Muertos, in all its resurrected glory. With a margarita in hand and an ocean in front of me, ignored, I turned my attention to my phone to get to the bottom of Neon version 3.0. Introduced for 2016, today's Dodge Neon is based upon and built alongside the Fiat Tipo/Egea, a C segment compact sedan co-developed by Fiat and Turkish industrial outfit Koc Holding. More than 125,000 were sold last year in Europe, with another 47,000 in Turkey. It's also sold in the Middle East and Africa, with Mexico alone getting the Neon version. Exterior styling is really the only difference, and then, only the crosshair grille manages to identify it as a Dodge. Then again, the same could be said for the not-so-dearly departed Dart, which belonged to the same segment. It was much bigger, though, with an extra 6 inches of overall length and 3 inches of wheelbase (which, as I just discovered, is "distancia entre ejes" en espanol). The Neon interior, not surprisingly, is pretty much the same as its Fiat siblings. The dash has two variations. A bigger, upgrade touchscreen resides in a dash-mounted, tablet-style infotainment pod, but the standard stereo head unit or 5-inch touchscreen upgrade fits into a binnacle shared with the instrument panel. It's a bit more like the Challenger, Charger, and yes, Dart in this regard, but in total, the Neon's cabin design is also less blocky and more organic in appearance. The switchgear is pure Fiat, but the steering wheel has the same control layout as Dodges, Jeeps and Chryslers. Power comes from the Challenger Scat Pack's 6.4-liter Hemi V8. No, it doesn't, I totally got you. The standard engine, dubbed FIRE, is a 1.4-liter naturally aspirated four-cylinder good for 95 horsepower and 94 pound-feet of torque. So, less than the Scat Pack. The optional engine, dubbed E.TorQ, which is in no way related to the Ram's eTorque mild hybrid system and not especially eTorquey, is a 1.6-liter naturally aspirated four-cylinder good for 110 hp and 112 lb-ft. Sadly, the Neon color selection is in no way neon, which probably doesn't matter since virtually every car on the Yucatan peninsula is painted white.

Dodge to reveal Hellcat-powered Challenger in Detroit?

On top of all the other performance car debuts slated for next week's Detroit Auto Show, we might be able to add one more to the list - the new, supercharged Hellcat V8 from Chrysler. According to new reports, the rumored 640-horsepower mill is likely to cross the Motor City stage in the engine bay of a Dodge Challenger.
As AllPar points out, though, there may be more news than just the fire-breathing engine. While we've seen spy photos of the Hellcat testing under the hood of the current Challenger, there's a very fair chance that it won't arrive until the muscle car is refreshed later this year. The question now is whether that refresh will be shown off alongside the new engine in Detroit, or if it'll be saved, perhaps for the New York Auto Show.
Other details dug up by AllPar include potential transmissions for the supercharged engine - the Mopar-minded site is expecting an eight-speed automatic or a Tremec six-speed manual. Prices, meanwhile, could be in the same elevated range as the Chevrolet Camaro Z/28, at $70,000 to $80,000.