1941 Dodge Wc1 on 2040-cars

Auto blog

2020 Ford Explorer ST vs 2019 Dodge Durango SRT: How they compare on paper

For a few years now, the Dodge Durango SRT has been the sole three-row performance crossover from a non-luxury brand. That all changes now that the 2020 Ford Explorer ST is coming to market. Now we have two family crossovers with rear-drive-based platforms vying for buyers that demand practicality and power. As such, there's no better time to dig into their specs to see how they compare. We'll check out each crossover's horsepower, torque, space, capability and prices. The full specs are listed below, followed by some analysis afterward. We also compared the regular 2020 Explorer models to other crossovers in this segment, if if that's not enough, you can check out our car comparison tool. Performance The Explorer and Durango go about making power in very different ways. The Explorer goes the force-fed route with two turbos feeding a 3.0-liter V6, while the Durango's enormous 6.4-liter V8 produces power with air flow au natural. Of the two, the Durango has the greater output of 475 ponies and 470 pound-feet of torque, feeding the flames of everyone that lives by the phrase "There's no replacement for displacement." The Explorer is no slouch at 400 horsepower and 415 pound-feet of torque, though. Performance isn't purely based on power, though. Other factors play a role, such as weight, and in that regard, the Explorer is way ahead. At 4,701 pounds, it weighs a massive 809 pounds less than the portly Durango. This also means that both crossovers are very close in weight-to-power ratio, with the Explorer only slightly worse at 11.75 pounds per horsepower and the Durango at 11.6. Less weight will also play a roll in handling, and the Explorer is likely to feel sprightlier without so much mass to shift back and forth. Semi-related to handling are tire sizes. The Durango features 295-mm wide tires on 20-inch wheels. The Explorer has 255-mm wide tires on 20-inch wheels, but 21-inch wheels with 275-mm tires are available. So the Durango is working with more contact patch, but as we mentioned, it's carrying a lot more weight. 2020 Ford Explorer ST View 20 Photos Interior Space and Practicality Although the Durango SRT is the largest on the outside in every dimension, it loses out to Explorer repeatedly inside. The Ford has more headroom, leg room and shoulder room in nearly every row except the third-row where headroom comes up a bit short.

Chop the top of your new Dodge Viper for $35,000

We have good news, and we have bad news. First, the good: It's now possible to get a brand-new Dodge Viper roadster, which is nice, considering we're in the dead of summer and many of us like wind-in-the-hair motoring. Now, the bad: This is not a factory option from the automaker, instead coming courtesy of an aftermarket company called Prefix Performance, and that means it's going to cost you some serious coin.
Called Medusa, this drop-top Viper was created without the knowledge or consent of Dodge, but that's probably fine because Prefix works with the automaker already for the final preparation of the American supercar, including paint. According to the company, the current, fifth-gen Viper was built with a convertible version in mind, so no chassis strengthening is required. From the looks of the somewhat grainy photos available, the conversion appears of very high quality.
Want one? Well, that means you're going to need to procure a Viper - Prefix has 10 units ready for transformation as it stands - and that's going to cost at the very least $102,485. Then, you'll need to write a check for an additional $35,000 for Prefix to surgically remove the car's roof. Thing is, for that kind of cash, a prospective owner could buy, among other very nice options, a Viper hardtop and a loaded Miata, or a Corvette Stingray convertible and several pockets full of change. Or, perhaps a new Viper hardtop and a used, first-gen Viper convertible?

Chrysler readying Hellcat V8 with Viper-like power

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.