2 Door R/t Mopar Muscle Rwd 350 5.7l Hemi Black Leather Financing Coupe on 2040-cars

Auto blog

NHTSA is investigating FCA shifters for roll-away accidents again, this time the rotary units

It seems FCA's shifter troubles aren't over yet. Now, just a few months after issuing a recall to resolve user-related issues with its monostable shifters, the company is again under investigation by NHTSA. The issue is related to the potential for cars to roll away when the rotary-style shifter is not properly placed in park. Two FCA models are the subject of this investigation: the 2013–2016 Ram 1500 and the 2014–2016 Dodge Durango. NHTSA estimates about 1,000,000 vehicles would be affected if a recall is issued. The investigation was started following 43 complaints of vehicles rolling away while supposedly being in "park." Among the complaints were reports of 25 crashes and 9 injuries. NHTSA does point out that in every incident, the parking brake was not engaged. A representative from FCA also gave us an official statement regarding the investigation: "FCA US is cooperating fully with NHTSA's investigation, the scope of which is limited. Other vehicles equipped with rotary shifters are not included. In accordance with prudent practice, the Company joins NHTSA in urging all drivers to use their vehicles' parking brakes." View 35 Photos As mentioned above, other Chrysler products with rotary shifters, such as the Pacifica minivan and 200 sedan, are not involved in this investigation. One of the key differences, as the representative told us, is that these vehicles have electronic parking brakes that automatically engage if the driver does not select park and then opens the door with the seatbelt unbuckled. The Ram 1500 and Durango feature mechanical, manually operated parking brakes and therefore cannot activate the brake automatically. Because this is currently an investigation, an exact cause for the incidents has yet to be determined, and none of the vehicles have been recalled. It's possible there could be a mechanical defect. However, the issue could be a confusing interface causing user error, as was the case with FCA's monostable shifters, where drivers think they've put the car in park but actually haven't. Something that indicates it could be a case of confused users is that NHTSA also opened an investigation into 2012–2014 Jaguar XF and Land Rover Range Rover Evoques for similar issues. Both vehicles use a rotary shifter and have had roll-away complaints levied as well. Even if it is a case of user error, FCA and Jaguar Land Rover may still have to recall their vehicles.

Hellcrate 6.2-liter V8 delivers plug-and-play Hellcat hype to SEMA

SEMA just provided another entry for the folder marked "What A Time To Be Alive," with Mopar's announcement of the "Hellcrate" 6.2-liter supercharged Crate HEMI engine. Enthusiasts have been desperate to upgrade their vintage rides with the woozy thrills provided by Dodge's Hellcat motor, so Mopar answered. The Hellcrate engine assembly ships in plug-and-play configuration, in specially designed packaging with "Hellcrate" logos. The assembly sells separately from the Hellcrate engine kit, the kit adding a powertrain control module, power distribution center, engine wiring harness, chassis harness, accelerator pedal, ground jumper, oxygen sensors, charge air temperature sensors, and fuel pump control module. The PCM comes programmed with the production-car engine's 707 horsepower and 650 pound-feet of torque. An optional front-end accessory drive kit contributes peripherals like alternator, power steering pump, belts, and pulleys. Don't bother trying to lash up a sleeper 1997 Chrysler Sebring, though; Mopar tuned the Hellcrate for pre-1976 vehicles and manual transmissions. The engine assembly retails for an MSRP of $19,530, and the kit wants a further $2,195. Mopar didn't announce pricing for the accessory drive kit. The engine and kit come with a three-year, unlimited-mileage warranty when bought together. The Mopar Hemi Crate website will be happy to take your orders as of now. For help envisioning the possibilities, stop by Fiat Chrysler's 15,345-square-foot SEMA booth to check out the Limelight Green, Hellcrate-powered 1970 Plymouth Superbird clone worked up by Mark Worman of Velocity's " Graveyard Carz." While you're there you might as well peep Worman's encore, a 1968 Plymouth GTX stuffed with Mopar's 392 Crate HEMI in place of the original 440 big block, and the 1937 Dodge pickup that swallowed a Mopar 345 Crate HEMI. Mopar's come a long way from its original product: antifreeze products. Tomorrow it'll be Jeep's turn to ring the SEMA bells, once the noise dies down from the Mopar-jacked Wrangler Switchback, CJ66 and Jeep Shortcut. You can watch the brand's presentation online at 7:26 p.m. ET/4:26 p.m. PT. Until then, we're going to work the angles on a Hellcrate-powered Plymouth Volare. The sedan, naturally. Because we're practical. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.

2020 Dodge Charger Hellcat Widebody to race at Pikes Peak

The 2020 Dodge Charger Hellcat Widebody may be world's most badass Charger right now, but it won't be for long. This weekend, Dodge will unveil an even more serious Charger, a one-off racer that will run at Pikes Peak. Tim Kuniskis teased the race car during the Widebody reveal. It will have more power, more tire and more brakes than the road car. He didn't provide exact numbers for any of that, but we at least know it will have more than 707 horsepower, tires wider than 305 millimeters, and better brakes than the regular Hellcat. He said it will have an upgraded version of the Hellcat's 6.2-liter engine. We wouldn't rule out 797 horsepower like in the Hellcat Redeye and in the company's One Lap of America Dodge Durango. We suspect we'll have more concrete details and photos of the car very soon, since the Pikes Peak International Hill Climb takes place this Sunday. One other tidbit: Kuniskis said that we shouldn't expect any of the parts from the race car to show up as Mopar accessories. But we bet there will be plenty of aftermarket companies more than happy to help paying customers recreate it.