Lifted 5.9l Cummins Diesel Bed Liner Running Boards Leather Trailer Brk Pwr Lock on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

The Dodge Demon was developed under a cloud of smoke

The Dodge Demon needs no introduction. The car is so full of superlatives that most of it sounds unbelievable until you see and hear it in action. The car was revealed after months of teasers and cryptic messages, but the public weren't the only ones in the dark. From the start, the Demon's development was a closely guarded secret. There were even some within SRT that didn't know about the project. The people behind the car went through a lot of effort to keep it that way. At an event covering the finer details of the Demon's supercharged 6.2-liter V8, Dodge CEO Tim Kuniskis and SRT Powertrain Director Chris Cowland spoke about the smoke and mirrors used to hide the Demon's development. Work on the car progressed for nearly two years before it was made public, with just a small team having full access to the project. Numbers were altered. Secret meetings were held. SRT engineers worked nights and weekends while parts suppliers were given as little information as possible to move progress forward. Preliminary work on the Demon began in April of 2015, not long after the standard Hellcat hit the streets. The goal wasn't to create a faster Hellcat. Kuniskis said that would have been easy. They wanted a single-minded vehicle that could also be driven on the road. It's the same mindset that brought about the Dodge Viper ACR. Dodge wanted a car that could sell the brand to both enthusiasts and non-enthusiasts alike. 840 horsepower is going to raise anyone's eyebrows, including the Camry owner parked down the street. While preliminary work started in April, the final greenlight wasn't given until September. The project was originally going to revive the American Drag Racer, or ADR, name. When we saw the first hints of the Demon last fall, we labeled the spy photo above the Dodge Challenger ADR. It was set to have 10-percent more power and 20-percent more launch force than the already gut-punching Hellcat. It was also only going to have a quarter-mile time in the 10s, just slightly quicker than the Hellcat. Somewhere along the line, the team realized that the ADR wasn't enough. It was just going to be a Hellcat plus, and that wasn't exciting. The main goal was changed: 9s with light. Translated, that means a 9-second quarter mile with light under the tires (read: a wheelie). From that point forward, everything about the Demon's development, from power to suspension to weight, would be done in pursuit of that goal.

The Dodge Demon's massive hood scoop sucks air like a jet intake

You know what they say about cars with big hood scoops? They usually hide big blowers. At least that's the case with the Dodge Demon and its 45-inch wide hood scoop, the largest ever fitted to a factory production car. The fifth Demon teaser, "Forced Induction," shows off the increased capacity of the car's air intake and the resurrection of the Air Grabber hood scoop on Dodge's upcoming quarter-mile killer. View 4 Photos As with previous teasers, few details have been given outside of the Subaru-trouncing scoop's dimensions. Dodge says the scoop drops air inlet temperatures by more than 30 degrees. Where the more pedestrian Hellcat only has one air catcher headlight, both inner lights on the Demon are used to feed in air. The hood itself appears to channel air in and to the right into a new airbox that appears to be fitted with a K&N-style filter. Dodge seems intent on preventing any asthma issues with the new car. Standing in front of the car might literally take your breath away. Outside of that, the images don't show any new cryptic messages like previous teasers, or at least none that we can spot. One thing we did notice was that the engine block appears to be painted red, not orange like on the Hellcat. Doing some back and forth comparison also shows that the supercharger appears to be the same size as the current one. Of course, this is all speculative, so if you spot anything, drop a note in the comments. Related Video: