Dodge Ram 2500 Mega Cab Laramie Diesel Sunroof Leather 3500 Ford F-250 Silverado on 2040-cars

Auto blog

2019 Dodge Challenger SRT Hellcat Redeye priced $14,000 below Demon

Steve Beahm, head of Passenger Car Brands at Dodge, SRT, Chrysler, and Fiat, told Motor Trend that the 2019 Dodge Challenger SRT Hellcat Redeye is "a Hellcat that's been possessed by a Demon." Turns out the Hellcat Redeye was also possessed by The Ghost of Great Deals. Dodge just released pricing for the Challenger line, the crimson-eyed terror at the top starting at $69,650, which is $13,645 less dear than the $83,295 MSRP for the 2018 Challenger SRT Demon. The asterisk: the Redeye needs the same $1,345 destination charge and $1,700 gas guzzler tax as the 2018 Demon, so the difference still holds once you get the Redeye off the dealer lot. The final tally: $72,995. Torque News acquired a copy of the Challenger dealer order guide, and options on the Hellcat Redeye will run you a little more than the bucket of $1 options on the Demon. Among the list, the summer performance tires add $695, the optional 3.09 rear axle adds $1,095, a painted black hood costs $1,995, and the Widebody package adds $6,000 for it's extra 3.5 inches. According to TN, you can run a standard Hellcat Redeye up to almost $90,000, and push a widebody to $95,000. The standard Challenger SRT Hellcat gets touched by the bargain bogeyman, too: the price goes down by $5,645 for 2019 to $58,650, even though it's been uprated by ten horsepower to 717 hp, and by six pound-feet to 656 lb-ft. Out-the-door price after a $1,700 gas guzzler tax and $1,345 destination fee is $61,695. Before including destination, there's a long way down to the next model, the 485-horsepower Challenger R/T Scat Pack at $38,995. Buyers who choose the six-speed manual for this trim will pay a $1,000 gas guzzler tax. The V6-powered, 305-hp Challenger GT in two-wheel drive starts at $29,995. Sending power to all four of the GT's wheels needs $32,995 before destination. The base model, two-wheel drive SXT gets the Challenger doors open at $27,295, the all-wheel drive model costing $30,295. Related Video:

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

2018 Dodge Challenger SRT Demon First Drive | Don’t fear the Demon

"If you're not hurt, we'll be really pissed. If you are hurt, we'll still be pissed, but not quite as pissed." These are the words from Jim Wilder, the vehicle development manager of the 2018 Dodge Challenger SRT Demon, that echo through our head as we slide behind the wheel of the car for the first time. He was warning us about driving beyond our abilities, and keeping the car out of the wall. With 840 horsepower and 770 pound-feet of torque on tap from its supercharged, 6.7-liter V8, the Demon does 0-60 miles per hour in 2.3 seconds, and 0-30 mph in a second flat. If something does go wrong, it'll happen quickly. Following that talk, we had our guts sloshed as a passenger in a blurry eighth-mile run, giving us a taste of the G forces (the Demon can pull 1.8 G in a straight line) we'd feel when we got in the driver's seat for our own pass down the drag strip. We're already sweating. It had rained - you could describe it as torrential - the day before. The grassy parking areas surrounding Lucas Oil Raceway were still flooded, but any water on the pavement had evaporated and hung in the air. Combined with the heat, we were sticky and uncomfortable. In Drag Mode, the Dodge Demon's air conditioning turns off. Any condensation that it could leave on the track would be a problem, plus we need to reduce parasitic power losses for a faster run. The system is still working, though, the refrigerant diverted to the chiller system cooling the air coming into the engine. There's still condensation, but the Demon collects it on a catch pad to keep it from ending up on the pavement. We're also required to roll the windows up when entering the drag strip. For one thing, it helps keep the smoke out of the cabin during the pre-staging burnout. So, yeah, it's hot as Hell in the Demon. We pull through the water box and run through the sequence – which involves holding the "OK" button on the steering wheel usually used to navigate menus, and applying a specific amount of brake pressure before getting on the throttle to initiate the burnout. This gets any crud off the rear tires and heats up the rubber. There are multiple ways to launch the Demon. We had an instructor sitting in the passenger seat as we pulled up to the beams that trigger the Christmas tree at Lucas Oil Raceway. He walks us through the most complicated of the three he had explained to us just minutes before when we were in the passenger seat.