2007 Dodge Ram 2500 Slt on 2040-cars

Auto blog

2014 Dodge Durango leaks ahead of NY rollout

Even though Chrysler will reportedly discontinue the Dodge Durango after the current model's lifespan - said to be around 2016 - that isn't stopping the automaker from improving its full-size, three-row SUV. The vehicle won't debut at the New York Auto Show until tomorrow, but images are already leaking out ahead of the embargo lift, and they show that the 2014 model is getting even more aggressive styling to go with more technology inside and out.
Dodge limited its early press shots of the new Durango to just the R/T trim level, but this new look adds a meaner look to this model with more dramatic projector-beam headlights along with a "floating" crosshair grille and a restyled fascia. At the rear of the Durango, LED racetrack taillights show a family resemblance to the Charger and Dart, while a new rear fascia adds to the styling while also allowing for an integrated trailer hitch.
On the tech side, the instrument panel looks to have been redesigned to include a standard seven-inch thin-film transistor (TFT) gauge cluster, and it also appears as if Chrysler's well-liked UConnect system has been updated with the 8.4-inch touchscreen found in other Chrysler vehicles. The 2013 model's conventional console shifter has been replaced by a rotary knob for gear selection, suggesting that there are transmission changes afoot as well. We'll have more details when the silks slide off this big boy tomorrow, so stay tuned.

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Dodge Viper ACR reportedly green lit [w/video]

The Dodge Viper might be getting a little more venomous in the near future thanks to a return of the performance-honed ACR trim. According to an anonymous source leaking the info to Allpar, the version would go into production in July as a 2016 model year vehicle. FCA US showed a concept for a future ACR (pictured above) at the 2014 SEMA Show that sported carbon fiber parts for the front splitter and dive planes, plus a picnic-table-sized rear wing. The body also received ducts at the rear to shoot cool air to the differential. A set of 15.4-inch carbon-ceramic brake rotors also brought things to a halt in a hurry. The company promised all the aero pieces were sculpted in the wind tunnel to give the coupe even more downforce. To shed weight, engineers chucked the radio, speakers, carpet and sound deadening out of the interior, and they replaced many bits with even more carbon fiber. All of the tweaks are necessary because the ACR moniker carries serious cachet for the Viper at the track, especially at the Nurburgring. One reportedly did a 7:22 lap around the 'Ring in 2008, and another improved that further to 7:12 in 2011. Autoblog reached out to FCA US for comment about the possibility for the hotter Viper, but the company wasn't willing to comment about any possible, future projects. Related Video: