1974 Dodge Dart Swinger Hardtop 2-door 3.2l on 2040-cars

Auto blog

Dodge Challenger SRT Hellcat #0001 raises $825,000 for charity

$60,000 doesn't strike us as a lot to pay for a muscle car with 707 horsepower on tap. $825,000... now that's a different story. But, according to the official SRT blog, that's how much one generous and eager buyer paid for the privilege of getting his (or her) hands on the very first new Dodge Challenger SRT Hellcat.
Decked out in Stryker Red paint that's usually reserved for the Viper, the supercharged Challenger bearing the VIN 0001 went up for auction at the Mandalay Bay hotel and casino in Las Vegas on Saturday under the auspices of Barrett-Jackson. By the time bidding ended, the gavel dropped at $825,000 - nearly 14 times the sticker price - 100 percent of which will benefit Opportunity Vehicle, a charity that aids the intellectually handicapped in the Las Vegas Area.

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

How to update and secure a vulnerable Chrysler Uconnect system

If you own one of the 1.4 million vehicles affected by the recent Chrysler software recall, you may want to watch this video. In it, we explain how to get the latest infotainment software loaded onto the 8.4-inch Uconnect system. The recall was a response to the findings of researchers who were able to hack into and remotely control a 2014 Jeep Cherokee through its cellular connection. Although Fiat Chrysler has worked with Sprint to plug most of the holes on the carrier side, there are still some vulnerabilities that only this latest software version can patch. Owners have three options to get the update: download it now, wait for a USB stick in the mail, or take the vehicle to an FCA dealer. Chrysler will be sending USB sticks loaded with the software update to customers. Anyone with an internet connection and a USB stick of their own with at least 4 GB capacity can speed things up by downloading the patch from the Uconnect website. We cover that process from start to finish in the video, with the final portion still applicable to those using the FCA-supplied USB stick. If after watching this you still don't want to tackle the patch yourself, you can take your vehicle to the dealer to have it done. Also note that this process is the same for all Uconnect updates, not just the one patching the exploits. Our demonstrator vehicle is a 2015 Ram 1500 pickup. The procedure should be very similar on other products with the 8.4-inch Uconnect system, with only the location of the USB port varying. Once you have the USB stick with the software on it – either after having downloaded it yourself or receiving it in the mail from Chrysler – the installation process is relatively simple. It takes about 15 minutes to perform the update; we edited out the wait in the video. To check whether or not your car's 8.4-inch Uconnect system is running the latest software, go to System Information on the touch screen's Settings page and look at Software Version. The update related to the recall is version 15.17.5. Related Video: Recalls Chrysler Dodge Jeep RAM Safety Technology Infotainment Videos Original Video hacking