Find or Sell Used Cars, Trucks, and SUVs in USA

1969 Dodge Coronet R/t 440hp 4spd on 2040-cars

Year:1969 Mileage:89000 Color: Red /
 Black
Location:

Manchester Township, New Jersey, United States

Manchester Township, New Jersey, United States
Advertising:
Transmission:Manual
Body Type:Coupe
Engine:440hp
Vehicle Title:Rebuilt, Rebuildable & Reconstructed
Fuel Type:Gasoline
For Sale By:Private Seller
Condition:

Used

VIN (Vehicle Identification Number)
: WS232E86D21XXXXXX
Year: 1969
Interior Color: Black
Make: Dodge
Number of Cylinders: 8
Model: Coronet
Trim: hard top r/t
Warranty: Unspecified
Drive Type: manual
Mileage: 89,000
Sub Model: R/t
Exterior Color: Red

1969 dodge coronet factory R/T 440hp 4spd. has air grabber hood with scoops no air cleaner air grabber parts.Its a Non n96 car. still has fender tag. NO motor or trans!! the dana 60 rear was removed long ago and replaced with the 8.75 rear end.Has all glass except for passenger side quarter glass. windshield is there but has some fogging on some of the edges of the windshield. Dash is complete with the Tic Toc Tac,  4spd pedal is intact ,original bucket seat car.3 speed wiper motor, manual steering and brakes, 4 wheel drum. when purchased owner said it was a track pack car but haven't had the chance to research it to see if it was true.
THE GOOD: roof,rear filler panel,sail panels,trunk lid,twilight panel,drivers side rocker, hood,cowl,pass fender. no rot some surface rust. rear frame rails and rear shock mounts are solid, firewall and inner front fender well are good. has police rims and trim rings. all tires hold air.has all window cranks,has taillights. trans tunnel is good. 
THE BAD: trunk floors, truck extensions,pass side rocker, floor boards front frame rails.has no seats.no grille 
i described this the best as i can if there is any doubts please contact before bidding!!! people with no feed back and bad feed back please contact first before bidding. this is a very rare car and deserves a restoration i just have to many projects ahead of this one!!! happy bidding!!!
NO TITILE SOLD WITH BILL OF SALE!!!

Auto Services in New Jersey

Young Volkswagen Mazda ★★★★★

New Car Dealers, Used Car Dealers
Address: 191 Commerce Park Dr, Asbury
Phone: (610) 991-9100

Wrenchtech Auto ★★★★★

Auto Repair & Service
Address: 2010 Union Blvd, Phillipsburg
Phone: (267) 424-0704

Ultimate Collision Inc ★★★★★

Automobile Body Repairing & Painting
Address: 2560B Richmond Ter, Cranford
Phone: (718) 448-5500

Tang`s Auto Parts ★★★★★

Automobile Parts & Supplies, Used & Rebuilt Auto Parts, Automobile Accessories
Address: 6219 1/2 Passyunk Ave, Riverton
Phone: (215) 729-3518

Superior Care Auto Center ★★★★★

Auto Repair & Service
Address: 120 19th St, West-New-York
Phone: (718) 768-0622

Sunoco ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Automobile Inspection Stations & Services
Address: 7701 Ventnor Ave, Pleasantville
Phone: (609) 823-1133

Auto blog

Chrysler investing $20M in Toledo plant to support 9-speed auto production

Sun, 28 Apr 2013

In 2011, Chrysler announced a $72-million investment in its Toledo Machining Plant to modernize production of the eight- and nine-speed torque-converters for automatic transmissions made there. That upgrade work won't be finished until Q3 of this year, but Chrysler has already announced a further $19.6-million investment to increase production capacity for the nine-speeders.
The extra units will be necessary because the nine-speed transmission they'll be mated to is going into three popular models: it will debut on the 2014 Jeep Cherokee, then go into the Chrysler 200 and Dodge Dart. The company predicted that this year alone it would sell 200,000 units equipped with the nine-speed tranny, and it is spending some $374 million in addition to the investment in Toledo to upgrade production capacity for it.
The work attached to this new investment won't begin until Q3 of 2014, and it will be finished by the end of that year. There's a press release below with all the details.

Dodge Challenger spied exercising supercharged Hellcat Hemi V8

Wed, 23 Oct 2013

One of the prime complaints against the Dodge Challenger is that, even in SRT8 guise, its 470 horsepower is responsible for hauling over 4,200 pounds of vehicle. For comparison, the 420 hp in the Ford Mustang GT only has to deal with 3,618 lbs. Things only get worse from there, as the higher-performance variants of both the Mustang and the Chevrolet Camaro are far more powerful than an SRT8 without adding on much heft.
So what is Chrysler to do? The correct answer is add a whole lot more grunt to its hefty two-door and even the odds. That's where the all-new Hellcat engine comes into play. We reported on this engine in May, and suggested that the Hellcat, a supercharged powerplant based on a 6.4-liter V8, would easily generate 500 to 570 hp and could likely arrive boasting more than 600 ponies.
Chrysler's ace in its sleeve has now been spied testing, with a number of Hellcat-equipped Challengers running the potent new engine both in more urbanized areas and under the sun of Death Valley. The hoods on these testers have been raised to accommodate the engine, and that camouflage over the fascias of these prototypes is there to hide a larger air intake. We also note what appears to be a new split grille under wraps. As for power output, our spies are now suggesting a Viper-equalling 640 hp from the Hellcat-equipped cars.

Watch a Dodge Viper driver show off his V10 all the way into a wall

Mon, Apr 11 2016

Has there ever been a show-off video that doesn't end terribly? This video clip captured with a cellphone shows the driver of a neon green Viper GTS giving a fellow motorist a couple throttle blips to signify his intent – which seems to be to crash the Viper into a concrete wall as quickly as possible. It's not pretty. The mean machine seems to be a second-generation Viper GTS in Stryker Green. To our knowledge, no photos have surfaced of the aftermath, so we wish both the driver and their most-likely bruised ego a speedy recovery. Who knows, maybe the Viper is also salvageable.