2014 Chevrolet Silverado 1500 Lt on 2040-cars

Auto blog

Ringbrothers drops more hints about its wild SEMA creations

Ringbrothers isn't finished teasing its SEMA creations. First we got a sliver of rear quarter on a 1969 Chevrolet Camaro that revealed a bundle of carbon fiber and SEMA-obligatory deep-dish wheels. The Wisconsin tuner's now announced its litter of cars headed to the show and a few specs, along with two shadowy drawings. The Camaro, christened with the name Valkyrja and a two-tone paint job, gets stretched in two directions with severe fender flares to widen the body and an extended wheelbase. We're not sure what's happening with the Camaro's snout in the drawing, but under that bulging hood we'll find a 416-cubic-inch LS V8 from Wegner Motorsports. Wegner built the 416-cu-in supercharged LS3 V8 that powered Ringbrothers' 1,000-hp G-Code Camaro in 2016.  The second member of the gang is a 1969 Ford Mustang Mach 1 dubbed Unkl. The exterior begs for attention with a deep blue sea paint job, deep front chin spoiler, bulging hood, yellow brake calipers, and what looks like a racing number inside a roundel on the doors. Unkl gets its motivation from a 520-cu-in Boss V8 built by Kaase Racing Engines, rumored to throw about 800 hp.    Finally, Ringbrothers is bringing its Cadillac Madam V for another Las Vegas go-round after giving the custom coupe some updates. The Madam V is a 1948 Cadillac Series 62 fastback coupe body placed atop an ATS-V chassis, first shown in 2016. The firm didn't elaborate on the changes, so all we can expect for now are the coupe's postwar good looks mixed with new-millennium engineering, and a 3.6-liter twin-turbo V6 with 464 hp under that exceptionally long hood.    For any in attendance at the show, the Valkyrja Camaro debuts at the BASF booth on Tuesday, Nov. 5, 2019 at 9:30 a.m., the Unkl Mustang gets revealed a couple hours later at the Flowmaster/Holley booth, and the Madam V Cadillac will be on display throughout the show at the Ringbrothers booth.

First 2015 Chevy Corvette Z06 engine blows up at just 891 miles

You've waited and watched and waited some more for the arrival of your 650-horsepower, $78,000 Chevrolet Corvette Z06. Finally, that joyous day arrives and you eagerly, but gingerly, begin to break-in the 6.2-liter supercharged V8 monster under your hood. Then 900-odd miles after delivery, your excitement grinds, quite literally, to a halt. That's what the owner of one 2015 Z06 claimed happened to him when a simple break-in drive resulted in a lunched engine. The owner, known as Lawdogg149 on Corvette Forum, says he was out breaking-in his car ahead of a January track event when it happened. "While making a pull from 35 miles per hour, I accelerated and shifted short of redline, and boom - the car began knocking. I pulled over and popped the hood. I could hear a loud knock coming from the No. 6 cylinder area along with a serious, grinding, metal-on-metal sound coming from the supercharger area," Lawdogg wrote. A subsequent trip to the dealer confirmed his concerns, with the service facility telling Lawdogg that the No. 6 valvetrain had failed. The dealer couldn't research the issue further, though, as General Motors requested the engine be returned for a more thorough evaluation. The good news for the Z06's unlucky owner, at least, is that GM will be covering the engine replacement under warranty, an expense that Corvette Forum estimates is a nearly $24,000 procedure. At this point, the two leading theories behind the engine's detonation involve a manufacturing defect – which could be why GM is so keen to tear the blown powerplant down – or a mistake on the part of Lawdogg. As Motor Authority points out, such an error could be something as simple as the Z06's owner accidentally shifting to first rather than third during his 35-mph pull. If, however, there's a deeper manufacturing problem with the Z06's engine, this might not be the only case we end up hearing about.

GM recalls 740,000 vehicles over daytime running light issue

General Motors is recalling over 740,000 vehicles due to a daytime running light issue that causes all of the affected cars to run afoul of Federal Motor Vehicle Safety Standards. Vehicles affected by this recall are spread across many of GM’s brands. Models include the 2020-2023 Cadillac CT4 and CT5, 2021-2023 Buick Envision, 2022-2023 Cadillac Escalade and Escalade ESV, 2022-2023 Chevrolet Silverado 1500, Suburban, Tahoe and 2022-2023 GMC Sierra 1500, Yukon, and Yukon XL. GM says that the daytime running lights may remain on in these cars when the headlights are activated. This is a problem, because FMVSS rules require that the daytime running lights deactivate once the headlights turn on. If the DRLs remain on, GM says that could result in additional glare, thereby increasing the risk of an accident. The cause of this failure to deactivate the DRLs comes from body control module software that “under a combination of certain pre-conditions, could fail to deactivate the DRLs,” according to GM. Other GM vehicles were tested, but due to a difference in software or hardware, they remain unaffected. If this is reminding you of another recent GM recall, youÂ’d be right, as GM recalled another 340,000 vehicles for the same issue last month. After that original issue was found within GM, the company began looking into its other cars to determine if the population was larger than originally thought. GM found the additional vehicles included in todayÂ’s recall have the problem. The fix will either be via an over-the-air update or it will require you to bring the vehicle into a dealer for a software update, depending on which vehicle you have. Owner notification letters letting folks know what is necessary are currently scheduled to go out on January 23, 2023. Related video: Cadillac Escalade Infotainment Review