2012 Chevrolet Malibu 4dr Sdn Lt W/1lt on 2040-cars

Auto blog

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Chevy, Lincoln dealers say they still want sedans

Detroit automakers have famously turned their backs on sedans as they make the strategic bet to double down on money-making trucks and SUVs, but dealers for at least two American brands are giving the companies contrary signals. In separate recent interviews with leading national dealer councils for Chevrolet and Lincoln, Automotive News reports that both brands’ dealers still see a need for cars. The publication published a Q&A interview with Mike Bowsher, chairman of the Chevrolet National Dealer Council, who said Chevy dealers managed to hold onto market share last year despite the phase-out of the Cruze compact sedan and hatchback, thanks to products like the Spark and Sonic subcompacts and the Trax and Equinox crossovers. But, he acknowledged, “We do feel like we could use a car, especially in the low-MSRP range.” The comments follow similar recent comments from Tom Lynch, who chairs the Lincoln National Dealer Council. He told AN, “If weÂ’re not in segments where there is still a good amount of business, I think the company and the dealers lose out.” The Cruze was one of the victims of GMÂ’s November 2018 announcement of plant closures, with production having ceased with the closure of GMÂ’s Lordstown, Ohio assembly plant last year. GM sold 47,975 Cruzes in 2019 but a healthy 142,617 in 2018. At Lincoln, Lynch said the council has been telling the company it needs to stick with the sedan segment, despite plans to kill the MKZ sedan in the coming months and unconfirmed reports that the Continental isnÂ’t long for this world, either, despite the buzz of the suicide-door Coach Door Edition, shown in the photo above. Lincoln sold 17,725 MKZs and 6,586 Continental sedans in 2019, down a combined 15%, but still good for almost 22% of overall Lincoln sales. It's worth noting that Lincoln competes in a luxury segment that still expresses allegiance to four- and two-door cars. Even Cadillac, its cross-town rival, is staying active with the upcoming CT5 and CT4 sedans. Lynch pointed to Tesla as evidence that strong sedan products can resonate with consumers, though he conceded that “What that looks like for Lincoln going forward, IÂ’m not sure of.” For now, anyway, Chevy still offers the Sonic and Spark subcompacts, the latter of which saw sales climb 32.5% in 2019 to 31,281 (Sonic sales fell nearly as steeply).