Find or Sell Used Cars, Trucks, and SUVs in USA

Chevrolet Chevelle Ss on 2040-cars

US $14,000.00
Year:1972 Mileage:55227 Color: Burgundy
Location:

New Providence, New Jersey, United States

New Providence, New Jersey, United States
Chevrolet Chevelle SS, US $14,000.00, image 1
Advertising:

Power steering and power brakes . Automatic with air conditioning. Has been repainted once ( not original color). The car has had quarter panel skins, but the other sheet metal is believed to be original. Car runs and drives fine

Auto Services in New Jersey

Young Volkswagen Mazda ★★★★★

New Car Dealers, Used Car Dealers
Address: 191 Commerce Park Dr, Asbury
Phone: (610) 991-9100

Wrenchtech Auto ★★★★★

Auto Repair & Service
Address: 2010 Union Blvd, Phillipsburg
Phone: (267) 424-0704

Ultimate Collision Inc ★★★★★

Automobile Body Repairing & Painting
Address: 2560B Richmond Ter, Cranford
Phone: (718) 448-5500

Tang`s Auto Parts ★★★★★

Automobile Parts & Supplies, Used & Rebuilt Auto Parts, Automobile Accessories
Address: 6219 1/2 Passyunk Ave, Riverton
Phone: (215) 729-3518

Superior Care Auto Center ★★★★★

Auto Repair & Service
Address: 120 19th St, West-New-York
Phone: (718) 768-0622

Sunoco ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Automobile Inspection Stations & Services
Address: 7701 Ventnor Ave, Pleasantville
Phone: (609) 823-1133

Auto blog

GM recalls select Tahoes, Yukons, Escalades for rear driveshaft issue

Mon, Feb 7 2022

GM is recalling a number of its full-size SUVs due to an issue with the rear driveshaft assembly that could ultimately result in driveshaft failure. The actual number of total vehicles involved in the recall is small at just 1,789, but it’s spread out across the entire 2021 model year full-size GM vehicle lineup. That means a small number of every model is being recalled, including the Chevrolet Tahoe, Suburban, GMC Yukon, Yukon XL and the Cadillac Escalade and Escalade ESV. GM traced the issue back to certain driveshaft assemblies with ball bearings that were not properly heat treated. If theyÂ’re not properly heat treated, GM says that the balls may deform over time, causing noise and vibration. Continue to drive in this condition, and GM says the affected joint in the driveshaft assembly could seize, causing loss of drive power. However, the problem wonÂ’t present itself all at once, as GM says there will be a gradual increase of noises and vibrations before total failure. For those few owners with affected vehicles, GM says that it will replace the left and right rear driveshaft assemblies with properly-built units. Per usual with recalls, this will be done at your local dealership at no cost to the owner. If you have one of the recalled SUVs, expect to be notified mid-March. Related video:

Final C6 Corvette built in Bowling Green

Fri, 01 Mar 2013

With all of the attention given to the 2014 Chevrolet Corvette Stingray lately, you could be forgiven for thinking that it's already well along in production, yet tooling up for the new C7 has only just begun. In fact, production of the outgoing C6 generation in Bowling Green, Kentucky just halted on Thursday.
As the C6 has aged, production numbers have predictably ebbed along with demand, but this year, the addition of the 427 and 60th anniversary models resulted in an uptick in vehicles built - this, despite a model year shortened by around 25 percent to accomodate the new model changeover. The final C6 Corvette ever, No. 13,466 built this year, was a white 427 Convertible destined for the General Motors Heritage Center museum. The car's 7.0-liter V8 heart was assembled by Corvette chief engineer Tadge Juechter himself.
In total, Bowling Green pushed out 215,100 C6 Corvettes over nine years. If you're still a C6 fan at heart and are hoping to get a good deal on a phase-out model, step lively - Chevrolet reportedly had about 6,100 unsold units, which Autoweek suggests is good for around five and a half months of supply at the model's current sales rates. Given that demand will likely slacken even further as the C7 draws closer, that should be a big enough stockpile to keep dealers satisfied until 2014 Stingrays begin showing up on their forecourts in December.

Chevrolet Colorado ZR2 concept suggests a diesel off-road future

Thu, Nov 20 2014

"It takes the Colorado to a whole new place." – Mark Reuss The Chevrolet Colorado looks set to gain a more capable off-road version, with the company previewing a potential design direction with a ruggedized concept Wednesday at the Los Angeles Auto Show. Called the Colorado ZR2, the concept brings back the name used on off-road-tuned S-10 and Blazer models in the 1990s and 2000s. The ZR2 has a track that's four inches wider than the Colorado Z71, which is currently the line's most capable off-roader. The ZR2 is fitted with a new grille, power-dome hood, custom wheel flares and off-road-style fascia that reduces overhang and has flip-out aluminum tow hooks. It's all slathered in an outdoorsy hue dubbed Cyprus Green. The are electronic locking front and rear differentials, skid plates and mono-tube coilover shock absorbers. It all rolls (or crawls) on 275/65R18 off-road tires wrapped around custom 18-inch aluminum wheels. There's also a spare tire assembly mounted in the bed, which has a spray-in liner and 48-inch lift jack should things go afoul on the trail. "It takes the Colorado to a whole new place," Mark Reuss, General Motors executive vice president of global product development, said at the reveal. Power comes from the 2.8-liter Duramax diesel engine making 181 horsepower and 369 pound-feet of torque. This engine will arrive later in the year in the production Colorado. While the ZR2 remains only a concept, it suggests a new path for the Colorado – one we hope Chevy decides to take. Chevrolet Introduces Colorado ZR2 Concept Aggressively styled, more capable and driven by new 2.8L Duramax diesel engine LOS ANGELES – Chevrolet today introduced the Colorado ZR2 concept – a vision of how Chevrolet could take the all-new midsize truck's off-road capability to the next level. It also showcases the new 2.8L Duramax diesel engine that will arrive in the Colorado lineup later next year. The aggressively styled concept builds on the capabilities of the production Colorado Z71 and advances the legacy of Chevrolet's previous ZR2 production models. "From the bold stance to the trail-ready special equipment, the Colorado ZR2 is all about the fun of driving where the pavement ends – and doing it in characteristic Chevy style," said Tony Johnson, Colorado marketing manager.