01 4x4 Awd 6 Cylinder Auto Transmission Air Conditioning Power Windows Cheap on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Burt Reynolds' vehicles up for auction at Barrett-Jackson

Burt Reynolds' influence on car culture cannot be overstated. Be it "Smokey and the Bandit" or "Cannonball Run," his films inspired a generation of car enthusiasts. He died a few weeks back from cardiac arrest at age 82. This weekend, four vehicles from Reynolds' personal collection — three Pontiacs and a Chevy — will go up for auction at Barrett-Jackson in Las Vegas. It seems Reynolds had plans to sell the cars before he passed. He even filmed a short teaser for the auction and planned to attend the event himself. Three of the cars are Pontiac Trans Ams. Two are re-creations of the cars he drove in "Bandit" and the film "Hooper." Both are 1978 models. The third Trans Am is from 1984 and was used to promote Reynolds' USFL team, the Tampa Bay Bandits. The fourth vehicle is a 1978 Chevy R30 pickup truck. It's styled like the truck he drove in "Cannonball Run." None of the vehicles were actually used in the movies. But they were registered in his name, making them far more legitimate than some other movie-inspired clones. It's unclear how many Bandit Trans Ams Reynolds has owned over the years. Another car connected to him sold for $450,000 back in 2014. His death is sure to drive the price of these new cars even higher. Related Video: Image Credit: Barrett-Jackson Celebrities Chevrolet Pontiac Auctions Truck Coupe pontiac trans am burt reynolds

Genovation Cars readies all-electric Corvette prototype

Chevy runs the full spectrum from some of the most environmentally friendly cars to the least. At one end are EVs like the Spark and Volt. At the other, performance models like the Camaro and Corvette. But one American company wants to bridge that divide. That company is Rockville, MD-based Genovation Cars, which reports that it is almost done building its prototype for an all-electric Corvette. Dubbed the Genovation Extreme Electric (or GXE for short), the prototype is based on a previous-generation 2006 Chevy Corvette Z06, but ditches its enormous 7.0-liter V8 for an array of inverters, batteries, and electric motors said to be good for over 700 horsepower and 600 pound-feet of torque. That promises to deliver a 0-60 time of about 3.0 seconds and a top speed in excess of 200 miles per hour. Those are supercar benchmarks for performance if we've ever seen them, and ought to leave even the top-spec Tesla Model S P85D in... well, not a cloud of smoke, but whatever the electric equivalent is, in a non-polluting cloud of that. The GXE is also supposed to be able to travel for 150 miles on a single charge, and handle well while it's at it with 50/50 front-rear weight distribution and a low center of gravity. Sorta like the Power Wheels 'Vette pictured above, then, but bigger and faster. Look for the GXE to debut at the Electric Vehicle Technology Expo this coming September in Michigan, after which Genovation says it will put the GXE to the test on the track to back up its performance claims. Genovation Cars Nearing Completion of High-Performance All-Electric Corvette, the GXE ROCKVILLE, Md.--(BUSINESS WIRE)--Genovation Cars is nearing the completion of a prototype high-performance all-electric Corvette called the Genovation Extreme Electric or GXE. Assembly of the GXE will be completed by the end of July, followed by a three-week testing phase. The GXE is based on a 2006 Z06 Corvette. Several contributors to the GXE effort have helped design and build record-breaking electric vehicles. They include an MIT electrical engineer and a mechanical engineer from Cosworth. "We are using state of the art inverters, batteries and electric motors that will produce in excess of 700-hp and 600 lb-ft of torque," said Genovation CEO Andrew Saul. "We expect the car to achieve 0-60 mph in around three seconds and have a top speed of over 200 mph.