2014 Chevrolet Suburban Lt on 2040-cars

Auto blog

2016 Chevy Camaro performance figures released

If you want to make a car faster, there are two sure-fire ways to get the job done – add power and/or reduce weight. Chevy has done both for the 2016 Camaro, putting as much as 455 horsepower into its muscle coupe and shaving a few hundred pounds from every trim. That range-topping power comes courtesy of a 6.2-liter V8 engine, and it's enough grunt to push an automatic-equipped Camaro SS to 60 miles per hour in just 4.0 seconds flat (4.3 seconds with a manual) and down the quarter mile in 12.3 seconds at 116 mph (12.5 at 115 for the stick). Not coincidentally, those acceleration specs, at least on paper, put the V8-powered Camaro SS just above the Mustang GT on the muscle-car pecking order. When the road gets twisty, Chevy claims the Camaro SS can generate as much as .97 g on the skidpad. And, thanks in part to its Goodyear Eagle F1 summer tires, the SS can stop from 60 in as little as 117 feet. We look forward to finding out how nimble the new Camaro feels when compared to its primary competitors. <p>Your browser does not support iframes.</p> Moving down one notch to the 335-hp 3.6-liter V6, properly equipped 2016 Camaro coupes can hit 60 in as few as 5.1 seconds and cover the quarter in 13.5 at 103. Perhaps even more intriguingly, the 2.0-liter turbocharged four-cylinder and its 275 horsepower (the only configuration quicker with a manual transmission, incidentally) can propel the Camaro to 60 in 5.4 seconds and through the 'ol 1320 in 14 seconds flat. That's seriously quick, but buyers comparing the Camaro to the Mustang will find that the EcoBoost 2.3-liter is a bit more powerful (310 hp and 320 lb-ft) and quicker (5.1 seconds to 60). Chevy is making lots of noise about the efforts its engineers went through to shed weight from the 2016 Camaro, going so far as to shave down suspension bolts so that no thread went unthreaded. The weight-saving obsession pays off – base Camaro models are down 390 pounds while the SS model drops 223 pounds over the 2015. The 2016 Camaro SS boasts a power-to-weight ratio of 8.1 lbs per pony, a 14-percent improvement over the last-gen. Even though weight is down, chassis stiffness is said to be up by 28 percent over the fifth-gen Camaro coupe. Also of note: The Camaro is now lighter than the Mustang across the board when comparing like-to-like configuration levels. The 2016 Chevy Camaro starts at $26,695 (including $995 for destination).

UAW to vote on strike at Kentucky Corvette plant

The current wait time for a new Chevrolet Corvette Stingray is well, not short. With word of a strike at the Bowling Green, KY factory responsible for seventh-generation sports car, though, that wait time could end up growing substantially.
Now, a strike is still a ways off. UAW Local 2164, which represents the 800 workers responsible for screwing the Corvette together, is set to vote on authorizing a strike today, but even if the employees give the action a go, it's far from a sure thing. According to The Tennessean, both regional and national union officials would need to put their stamp of approval on strike action.
"The membership has to vote to strike, but it's just a step in the process," said Gary Casteel, the UAW's Region 8 director and one of the people that would need to authorize a strike action. Casteel told The Tennessean, "It's purely a local situation, though. They are having some issues with the local management."

Experimental mid-engine XP-819 Corvette going up for auction

It seems to be commonplace that when a new Corvette is in development, rumors swirl about a possible mid-engine layout. As is the case of Chevy's most recent C7 Corvette, these rumors never pan out.
In any case, the idea for a 'Vette with an engine mounted behind the driver can probably all be traced back to a single car, the 1964 XP-819 prototype. Built as an "engineering exercise" back in 1964, the prototype was designed with a rear-mounted engine. History tells us that the idea of a rear-engine Corvette fizzled, and the XP-819 was eventually cut up into pieces and stored at a shop in Daytona Beach, FL.
After sitting for untold years, a restoration project started on the car, and while it isn't yet fully completed, the current owner of the car, Mid America Motorworks, will have the car on display at the 2013 Amelia Island Concours d'Elegance as a "driveable chassis" with hopes of having a fully completed car ready to bring to next year's show.