2006 Chevy Silverado 2500 Hd Duramax on 2040-cars

Auto blog

2016 Chevrolet Camaro First Drive [w/video]

The Autoblog gang was downright stoked to learn the 2016 Chevy Camaro was next on our test-car docket. Then we found out it was the V6 model. Buzzkill. We were hoping for the snorting V8, or at least the spunky new turbo four-cylinder. The V6? Meh. We've been driving V6 Camaros for, like, six years. It's what you buy if you can't afford anything better, or so say horsepower snobs as they wrinkle their noses and cut their coffee with 93 octane. But after a week with the six-pot Camaro, we'll admit it: we were wrong. The all-new 3.6-liter V6 is strong, sounds good, and is damn fun to drive. Its 335 horsepower and 284 pound-feet of torque appear modest by modern standards, but they power the Camaro to 60 miles per hour in 5.1 seconds with the automatic, or in the case of our manual-equipped test car, 5.2 seconds. That's almost half a second quicker than the new turbo four-cylinder model. Yes, it has the same displacement as the old V6. No, it's not the same engine. Upon closer inspection, the V6's potency shouldn't come as a surprise. This engine is from General Motors' newest family of dual-overhead cam powerplants that launched in the Cadillac CTS and ATS. Yes, it has the same displacement as the old V6. No, it's not the same engine. Don't be fooled, and don't underestimate it at stoplights. The strapping V6 is unsuspectingly good, but it's just one of many improvements for the sixth-generation Camaro. Chevy's coupe is lighter, faster, and more modern looking inside and out. It starts with a rear-wheel-drive chassis donated from the Cadillac ATS, though about 70 percent of the components are unique to the Camaro. The 2016 model is about two inches shorter in length (thanks to a shorter wheelbase) and about an inch has been removed from height and width compared to the 2015 model. These lighter underpinnings jumpstarted the Camaro's weight-loss plan, and thanks to extensive use of aluminum, the V6 with the new eight-speed automatic transmission weighs 3,435 pounds – 294 less than its predecessor (the manual-transmission V6 Camaro weighs 3,448 pounds). The V8, meanwhile, sheds 223 pounds. One by one, these elements would merely enhance how the Camaro drives, but taken collectively, they invigorate the new model. It feels much more confident and agile in all circumstances. Put simply, it's a sportier car. View 32 Photos Grab second, let the revs build, and the dual-mode exhaust changes its tune from a low buzz to a rumble, then a growl.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.

Chevrolet Silverado, GMC Sierra could get independent rear suspension

The Chevrolet Silverado and the GMC Sierra could reportedly receive a variant of the four-link independent rear suspension found under the new Tahoe and Suburban. While that's not a surprise, a recent report suggests electrification, not comfort, convinced General Motors to make the change. Replacing the time-tested solid rear axle with an independent suspension will improve comfort, handling and off-road prowess, while adding weight, and likely making the trucks a little bit more expensive. It's a fair trade-off, but GM Authority learned the real reason for the swap is that at least one of the pickups will spawn an electric model, and it's more difficult to package a bulky battery pack around a solid rear axle. The independent rear suspension takes up far less space, even if it has more moving parts. General Motors will build its first regular-production electric pickup on an evolution of the Silverado's T1 platform named BT1, according to the same source. The b stands for -- you guessed it -- batteries. The firm reportedly doesn't want to make two suspensions for cost reasons, so the independent setup will come standard regardless of whether the truck runs on gasoline, diesel, or electricity. As a bonus, Chevrolet and GMC could choose to offer their T1-based trucks with Magnetic Ride Control or an air suspension, options available on the 2021 Suburban and Tahoe. The independent rear suspension will also find its way to the next-generation GMC Yukon due to be revealed January 14, and to the 2021 Cadillac Escalade scheduled to make its debut February 4. The long-rumored, born-again Hummer will get it, too, because it will arrive as an electric model built on the BT1 platform. It's worth noting none of this is official, and General Motors has remained quiet about what's next for its new suspension design, and what will be under its electric truck's sheet metal. If the GM Authority report is accurate, the Silverado (pictured) and the Sierra could ditch their solid rear axle for the 2021 model year. The change will likely be accompanied by other tweaks inside and out. Featured Gallery 2019 Chevrolet Silverado 1500 View 16 Photos Chevrolet GMC Truck