2002 Rally Red 35th Anniv Ed T-top Ss Performance Slp 345 Hp on 2040-cars

Auto blog

GM recalls 3,300 pickups and SUVs for new ignition-switch issue [UPDATE]

UPDATE: A statement from GM about the recall has been added below. The exact total of vehicles affected is 3,296, including 3,073 of them in the US. General Motors isn't letting an ignition-switch problem grow into a massive scandal again. The automaker is recalling about 3,300 North American trucks and SUVs. They are: the 2014 Chevrolet Silverado and GMC Sierra and the 2015 Chevy Suburban and Chevy Tahoe, as well as 2015 model heavy-duty pickups, the Detroit News reports, citing an Associated Press story. The issue appears to have been caught fairly quickly. In this case, the keys can get stuck in the "start" position and then slip to "accessory" if bumped. This is because the ignition lock gears have an outer diameter that's larger than the specifications allow. When that happens the engine shuts off, and the driver loses assistance to the steering and brakes. The airbags might also be affected. The vehicles get a new ignition-lock housing to fix the problem. According to the Detroit News, an employee who experienced the problem with the switch discovered the issue, and this person then let officials at the automaker know as part of the Speak Up for Safety program. A total of five reports of the fault were discovered. However, there are no cases of injuries or crashes. The claims to the automaker's resolution program eventually tallied that GM's previous ignition switch problem included 124 deaths and 275 injuries. The company also had to recall millions of vehicles and pay significant fines to the US government. GM Statement General Motors is recalling 3,073 full-size trucks from the 2014 and 2015 model years in the U.S. Some of these vehicles may have an ignition lock actuator gear with an outer diameter that exceeds specifications, which may make turning the ignition key difficult. The ignition key could get stuck in the "start" position. This may be more likely at higher interior ambient temperatures. If the vehicle is driven with the key stuck in the "start" position, and the vehicle experiences a significant jarring event or the vehicle's interior temperature cools, the ignition lock cylinder could move out of the "start" position, rotate past the "run" position, and move into the "accessory" position, leading to loss of power steering assist, power brakes and potentially air bag deployment in certain crashes. Dealers will replace the ignition lock housing.

GM warning 800,000 owners that their cars may need oil changes more frequently than they say

The days of changing your engine oil every 3,000 miles are long gone thanks to most cars having automatic oil monitoring systems, but about 800,000 General Motors vehicles apparently have incorrect monitoring software that is leading to premature engine component wear. According to Autoweek, certain 2010-2012 Buick LaCrosse, Regal, Chevrolet Equinox and GMC Terrain models equipped with 2.4-liter four-cylinder engines could be going too long in between oil changes resulting in a higher-than-normal number of warranty claims for the engine's balance chain. The balance chain links the balance shaft to the crankshaft, and a worn one can produce higher noise levels.
As a fix, GM dealers will be reprogramming the software for the monitors in an effort to reduce the interval between oil changes, which varies based on driving habits and conditions. Through February 2015, the software update will be done at no cost to vehicle owners, but since this is not a recall, after that point, it will be up to the discretion of dealers as to whether or not they will charge for the service. What isn't immediately clear is whether GM plans on giving assistance to out-of-warranty customers who are experiencing engine issues from the worn chain.

Very first Chevy Camaro found and restored

Restoring an important classic car can lead people down rabbit hole upon rabbit hole of discovered history in a process that's essentially automotive genealogy. Take the recent rejuvenation of the very first Chevrolet Camaro as an example. The owners started with a strong hunch that the vehicle might be something special and spent years researching to figure it all out before the mechanical work even began. Fisher Body kicked off work on the first Camaro on May 17, 1966, and it was delivered to General Motors just a few days later for final assembly. While the model has earned a place as an American performance icon since then, the original was built more to develop the production process and boasted just a 230-cubic-inch (3.8-liter) inline six and 3-speed transmission. After spending its first few months appearing in promotions, a Chevy dealer in Oklahoma got the gold car in December of '66. It was touted on the sales floor there for years, and the first private owner didn't come until 1969. This short documentary goes into astonishingly comprehensive detail about every bit of the first Camaro's history. If you just want to hear the story of the latest owners and their work to get the vehicle restored since 2010, skip about 11 minutes into the video. Or, of course, you could just enjoy the whole thing. News Source: PilotCarRegistry via YouTube, Camaro NewsTip: Chris P. Chevrolet Automotive History Auto Repair Maintenance Coupe Classics Videos history