2011 Chevrolet Avalanche 1500 Lt on 2040-cars

Auto blog

Camaro spy shots show subtly different grille, front fascia

It looks like there some changes in store for the Chevrolet Camaro - the only thing is that we just don't know what Chevy has up its sleeve. Looking at these spy shots, we'd initially be inclined to think that there is just a minor facelift or a new special edition, but upon closer inspection, there are a few oddities about this car that definitely have us intrigued.
The most obvious difference on this prototype is the slightly restyled front fascia with a smaller lower air inlet and the two-bar grille. Then we get to some of the car's mysterious details. For starters, this fascia has the SS vent above the grille, but it looks to be blocked off. Granted this could just be a one-off piece used for testing. What really piqued our interest was at the rear of the car where it has quad exhaust outlets that are used on the ZL1. Could this be the LS7-powered Camaro that we reported on back in December?
At this point, your guess is as good as ours as to what we're looking at here, so let us know in the comments what you think this could be.

GM ending stop-sale order on heavy-duty trucks

General Motors responded to an inquiry from Autoblog regarding a stop-sale order on its full-size heavy-duty pickup trucks. Here's GM's official statement. GM is committed to building the highest quality products possible. We paused delivery on a small number of HD pickups with the 6.6 liter Duramax engine last week to finalize an investigation into a potential quality issue. The investigation has been completed and the stop sale will be lifted for the small number of vehicles at dealerships.Customers can be assured GM’s heavy duty pickups are covered by a 5 year/100,000 mile powertrain warranty. The original article continues below. General Motors has reportedly sent its Chevrolet and GMC dealers a stop-sale order that applies to some examples of the 2022 Silverado HD, the 2022 Silverado MD, and the 2022 Sierra HD. The units affected by the stop-sale order may develop an engine-related problem. Citing anonymous sources, website GM Authority wrote that the Duramax 6.6-liter turbodiesel V8 in the affected trucks can hydrolock, which means liquid could enter the cylinders and cause a substantial amount of damage. The report does not specify where the liquid would come from; hydrolocking can happen by driving through a deep puddle of water, for example, but a large amount of coolant can cause it as well. The publication adds that the stop-sale order was assigned internal reference number N222362910. It also notes that the trucks included in it can't be sold, delivered to buyers, traded with another dealer, sent to auction, or even used for demonstration purposes until further notice. Earlier in April 2022, GM Authority reported that General Motors planned to buy back an unspecified number of Silverado HD and Sierra HD trucks due to quality-related issues with the 6.6-liter V8. Details about the problems experienced by customers haven't been released; all we know is that each truck will be replaced, though the replacement may not have the same equipment due to the ongoing chip shortage. Related video:

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.