Chevy Astro Van on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Chevy finishes restoration of damaged 1 millionth Corvette

When a sinkhole at the National Corvette Museum devoured eight, rare examples of the iconic American sports car last year, some of the victims emerged better than others. While damaged, the 2009 Corvette ZR1 Blue Devil was able to drive out under its own power, making for a fairly straightforward restoration. Meanwhile, the one-millionth 'Vette came out looking like a pancake. Bringing the convertible back to perfection has taken four months and 1,200 man-hours, but the milestone car is finally on display again. After being a brief exhibit at the National Corvette Museum, the millionth 'Vette was moved to the General Motors Design Center. There, a 30-person team started on the difficult restoration. "When we disassembled it, we found that each employee involved in building it had signed a part of the car, which was fantastic and moving to see," said GM executive Mark Reuss. Therefore, the team tried to retain as many original parts as possible. The damage was extensive, and repairs included straightening the front sub-frame damage, patching the seats, and carefully restoring the dashboard pad to maintain the signatures below. The hood, front fascia, and side sills were replaced with parts from a donor vehicle. To keep the 'Vette perfect, the team scanned the names and put them on the new components. In one case, they even went back to an original employee to sign a replacement part. Surprisingly, the engine and transmission were fine. With the work done, the National Corvette's Museum's revived exhibit is nearly complete. Five of the other cars aren't being restored, and the museum is bringing the 1962 Corvette back to life. <p>Your browser does not support iframes.</p> Chevrolet Fulfills 1 Millionth Corvette Restoration Pledge Sinkhole-damaged milestone returns to National Corvette Museum 2015-09-03 BOWLING GREEN, Ky. – After more than four months and 1,200 man-hours of painstaking craftsmanship, restoration of the milestone 1 millionth Corvette – a white 1992 convertible – is complete. It was unveiled today at the National Corvette Museum, where it returns as part of the permanent exhibit. The car was damaged on Feb. 12, 2014, when it and seven other rare Corvettes tumbled into a sinkhole that opened beneath the museum's Skydome area. Chevrolet pledged to restore it.

PickupTrucks.com's latest test results in a familiar winner [w/video]

PickupTrucks.com has gone and thrown the latest batch of half-ton pickups into a cage match to see who would come out on top. The site put the 2014 Chevrolet Silverado 1500, GMC Sierra 1500, 2013 Ford F-150, Ram 1500, Toyota Tundra and Nissan Titan through a battery of tests. Those included 0-60 miles per hour acceleration, 60-0 mph deceleration, fuel economy, a hill climb, and payload and towing. They even threw the rigs on an autocross course to evaluate overall handling. Each truck was given points based on how it scored in each evaluation.
Who came out on top? Somewhat surprisingly, the 2013 Ford F-150 walked away with the gold, though fewer than 50 points separated first and fourth place. Head over to PickupTrucks.com to read the full evaluation and the final results. You may be shocked to see exactly where some of the segment's newest additions placed. You can also watch a video on the test below.