2011 Toyota Highlander Base Sport Utility 4-door 2.7l on 2040-cars

Auto blog

Toyota recalls slew of models for possible airbag calibration defect

Toyota is recalling sixteen models from the 2009 to 2013 model years over a potential issue with passenger seat airbag calibration. In spite of the large number of different Toyotas covered by the recall, just 3,235 units are included. These were vehicles installed with accessories like leather seat covers and headrest DVD systems by Southeast Toyota Distributors, and during the modifications the passenger seat occupant sensor system might not have been calibration tested. If the sensors aren't set up properly, the passenger airbag might not work as it should.
Affected models include: Avalon, Camry, Camry Hybrid, Corolla, 4Runner, FJ Cruiser, Highlander, Highlander Hybrid, Prius, Prius V, Rav4, Sequoia, Sienna, Tacoma, Tundra and Venza. Scroll down for the relevant model years for each.
The National Highway Traffic Safety Administration indicates that the recall will begin this month. Southeast Toyota will inform owners, at which time they can take their Toyotas to dealers for testing and repair. The complete bulletin from the NHTSA with more information is below.

Shuttle-hauling Tundra finds permanent home in science exhibit

The idea of lifting a full-size pickup truck completely off the ground by hand might seem as likely as, say, said pickup truck towing a 150,000-pound space shuttle, but... hurray, physics! The same Toyota Tundra that towed the Space Shuttle Endeavour to its final resting place at the California Science Center is now on permanent display there as an exhibit that shows how a lever works.
Like all levers, this exhibit uses a fulcrum allowing people other than Superman to lift the 5,625-pound pickup (plus an extra 1,000 pounds for the rig). That's almost as impressive as the Tundra pulling 17 times its rated towing capacity back in October. Regardless, Toyota is once again cashing in on the publicity stunt and visitors to the science center get a live demonstration of a simple machine - we call that a win-win.

Toyota getting into 3D printing with i-Road in Tokyo

Think of it as Pimp My Ride for the Japanese green concept car set. Toyota is further publicizing its funky, really skinny, leaning i-Road electric concept vehicle by putting on a contest that, among other things, encourages folks to customize parts of the car's surface via 3D printing. Hey, it is a really small car. Toyota's Open Road Project in Tokyo, which will last about a year and will let about 100 participants work with 10 vehicles, also includes a component that lets contestants find the most creative parking spots by seeking out "small unused spaces with access to plug sockets" (we're sure Tokyo is full of them). What grabbed us, though, was the possibility of printing out panels for a three-wheeled car that's less than eight feet long and less than three feet wide. Earlier this year, we reported that Toyota would add five i-Road vehicles to a Tokyo carsharing pilot project. Toyota's unusual promotions for the admittedly unusual concept two-seater date back to early 2013, when the Japanese automaker featured a video of four i-Roads dancing their way through a sun-kissed Mediterranean village. Meantime, take a look at Toyota's press release below, and get more information on the project here.