1972 911t Targa With Mfi - A Gem In Connecticut on 2040-cars

Auto blog

All Porsche 911s to get turbos in 2015?

Currently, Porsche builds two turbocharged 911s - the Turbo and the Turbo S (and their cabriolet counterparts). The rest of the 911 range, meanwhile, is motivated by either 3.4- or 3.8-liter flat-sixes of varying outputs. This clear separation could be set to change in the very near future, though, as rumors continue to swirl that Porsche's rear-engined range could switch exclusively to turbocharged power.
This time, it's Car projecting that the 911 range will go turbocharged as part of a mid-cycle refresh, with the base Carrera's 3.4-liter dropping to 2.9 liters and adding an iron lung, bumping the entry level 911 up to 400 horsepower. Yes, a 400-horsepower, entry level 911. The Carrera S, meanwhile, will retain its 3.8-liter engine, but will also benefit from turbocharging, increasing output to 530 horsepower and 520 pound-feet of torque. So basically, it sounds like the current, 520-hp 911 Turbo will become the next Carrera S.
What does that mean for Porsche's traditional high-performance models? Well, it's a safe bet that the Turbo, Turbo S and eventual GT2 will be producing seriously huge power figures. Based on pure speculation, we wouldn't be shocked to see a 600-hp Turbo, with the S and GT2 increasing output markedly from there.

Jay Leno puts carbon fiber wheels to the test on a Porsche 911 GT3 RS

Jay Leno's Garage usually focuses on looking at cars new and old, speaking to their owners and then Jay taking a drive to see what he thinks. However, Leno throws his usual shtick to the curb this week to do a full product test of the carbon fiber wheels from a company called Carbon Revolution. If you're not interested in hearing about wheels for 18 minutes, don't worry. They get mounted on a Porsche and are tested back-to-back with stock wheels, and Leno takes the 911 for a track test, too.
While carbon-fiber wheels aren't exactly a new idea, Carbon Revolution's goal is to create a lightweight, one-piece product that can be mass produced. The company even claims that it already has a deal with an OEM automaker to offer them on a vehicle in a few years. The key to the technology is that it doesn't need an expensive autoclave to be made.
In the meantime, the company's carbon fiber wheels are available as an aftermarket option for about $15,000 a set, according to the video. They weigh in at about 15.5 pounds each and offer OEM-levels of stiffness, so they could cut some unsprung mass off of a performance car. Watch here as Jay and his mechanic Bernard lap Willow Springs and give their feedback about what they think of this cutting-edge technology.

Jaguar F-Type coupe to cost more than convertible?

Jaguar may price the much-rumored F-Type Coupe above the F-Type Convertible, if a report from Australia's Drive is to be believed. What makes Jag think that such a pricing strategy would work? Porsche. Take a look at the German manufacturer's consumer site, and you'll notice that the Boxster is less expensive than the Cayman, despite being essentially the same car.
It's a fair point, and a price premium does a good job of emphasizing the sporting chops of the coupe over the open-air experience that normally entitles convertibles to higher MSRPs. It's unclear just how closely Jaguar will follow Porsche's example, though.
Both the Cayman and Cayman S boast an extra ten horsepower over a Boxster or Boxster S, and while this bump in grunt is negligible in every situation but an argument over which is "best," it isn't something to be ignored in the F-Type, particularly as cranking more power out of its supercharged engines should be a rather simple matter.