Find or Sell Used Cars, Trucks, and SUVs in USA

1997 Mitsubishi Eclipse Spyder Gst Convertible 2-door 2.0l on 2040-cars

US $6,000.00
Year:1997 Mileage:160853 Color: Red /
 Tan
Location:

Tacoma, Washington, United States

Tacoma, Washington, United States
Transmission:Automatic
Body Type:Convertible
Vehicle Title:Clear
Engine:2.0L 1997CC 122Cu. In. l4 GAS DOHC Turbocharged
Fuel Type:GAS
For Sale By:Private Seller
VIN: 4A3AX55F0VE163796 Year: 1997
Make: Mitsubishi
Model: Eclipse
Warranty: Vehicle does NOT have an existing warranty
Trim: Spyder GST Convertible 2-Door
Options: Leather Seats, Convertible
Drive Type: FWD
Safety Features: Anti-Lock Brakes, Driver Airbag, Passenger Airbag
Mileage: 160,853
Power Options: Air Conditioning, Cruise Control, Power Locks, Power Windows
Sub Model: GST Convertible DSM turbo
Exterior Color: Red
Number of Doors: 2
Interior Color: Tan
Number of Cylinders: 4
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

Ok a bit about this car and me. This 1997 eclipse I bought as a project car with a blown motor... So i did a lot of research and found out that this model of a car has problems with the crank (they call it crank walk) which means that the crank throws out the thrust bearing which leads to engine failure... so after countless hours of research I discovered that the first gen (1g 6 bolt) engines have a better block design that prevents crank walk... so after I found the the right block i started to looking to making the perfect engine I knew that I need a 7 bolt crank since I wanted to keep automatic (since auto can hold up to 500hp with right mods). After more research I found that Manley Pistons and Eagle Rods will the Lightest possible combo... Once I got all of the bottom end put together I had to do a lot of custom work to get the to get the engine in... including the custom motor mount and pull system.. then I went for upgrading the turbo system I picked up a 05 Mitsubishi Evolution factory turbo and aftermarket manifold with downpipe... Both were customized to fit. also upgraded the intercooler to 500hp rated one with custom 2 and 1/2 inch piping and aftermarket BOV or blow off valve which is causing the the engine to idle rough.... can be fixed with a tune also needs new speed sensor. also the top was in bad shape and I didn't like the color so I got it replaced with a new black one (looks way better now)... now about the suspension I didn't like the ride height so I decided to lower it and the only company I could trust was Eibach... so I got the Eibach Pro-Kit springs with KYB GR-2 struts all around... then I did a full brake job and changed the wheels and tires... I got the 18 inch Motegi MR7 with Brand New 225/40 Toyo Tires in the front. So that is about the my project car and heres about me. The reason I'm selling my project car is I am getting married and I need money for the expenses and I ran out of money to complete this project. 

so the Highlights:

1g Block with 7 bolt crank 

Manley Pistons with Eagle Rods

ARP Head studs

Evo 8 Turbo, Manifold and downpipe

custom intercooler with piping

Gpower medallion exhaust

Eibach Pro-Kit lowering springs

KYB GR-2 struts

Motegi MR7 18" wheels with Toyo tires

New top

New brakes all around 

Additional Transmission Cooler

Runs and Drives
If you have any questions feel free to ask me I'm new to ebay so I don't if I missed anything

Auto Services in Washington

Xtreme Car Audio & Tint ★★★★★

Automobile Parts & Supplies, Automobile Radios & Stereo Systems, Consumer Electronics
Address: 25951 104th Ave SE, Des-Moines
Phone: (253) 867-6090

West Seattle Brake Service ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Brake Repair
Address: 4464 37th Ave SW, Keyport
Phone: (206) 935-4350

United Battery Systems Inc ★★★★★

Automobile Parts & Supplies, Battery Storage, Automobile Accessories
Address: 438 Oregon Way, Longview
Phone: (360) 577-3833

Skys Auto Repair & Detailing ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Car Wash
Address: 12620 Highway 99, Mukilteo
Phone: (425) 263-9442

Setina Manufacturing Co. ★★★★★

Automobile Parts & Supplies, Automobile Parts, Supplies & Accessories-Wholesale & Manufacturers, Used & Rebuilt Auto Parts
Address: 2926 Yelm Hwy SE, Lacey
Phone: (360) 491-6197

Salvage Yard Guru ★★★★★

Automobile Parts & Supplies, Used & Rebuilt Auto Parts, Automobile Salvage
Address: Marshall
Phone: (509) 850-5072

Auto blog

2014 Maserati Ghibli prototype spied for the first time

Mon, 17 Dec 2012

Looking to better compete with mainstream luxury automakers, Maserati has already announced its plans for expanding its model lineup. Now, these spy shots give us our first look at a new, smaller sedan that resurrects the Maserati Ghibli nameplate. Seen for the first time as a prototype rather than a Quattroporte-based test-mule, this is the closest-to-production view of the upcoming Ghibli thus far.
Aside from its name, we don't know much about the 2014 Ghibli, but we do hear that this Maserati, like the upcoming Maserati Levante SUV, will have a direct lineage to a Chrysler product. While the Levante will be based on the Jeep Grand Cherokee, it sounds like the Ghibli could use the Chrysler 300 as its starting point. This means that the standard version of the car could get Chrysler's 3.6-liter Pentastar V6 - rumored to produce around 400 horsepower - paired with the latest eight-speed automatic transmission; sportier trim levels would almost certainly get a V8 from Ferrari rather than using the 300C's Hemi.
As for some of the details apparent in the spy photos, we can obviously see the size difference between these two cars when comparing previous spy shots of the newly released 2014 Quattroporte, which we drove last week. We also see that this car gets some performance-oriented, cross-drilled brake rotors, and based on the depth of the snow in which this car was caught testing, we also wouldn't rule out the use of all-wheel-drive on the Ghibli.

Maserati Quattroporte suits up with Ermenegildo Zegna [w/video]

Wed, 11 Sep 2013

You know what no one has ever said? The Maserati Quattroporte needs more Italian style. Just the same, Maserati has teamed up with Ermenegildo Zegna to give the QP just that.
Revealed here at the Frankfurt Motor Show is the (deep breath now) Maserati Quattroporte Ermenegildo Zegna Limited Edition Concept. And by "concept", Maserati means it intends to put it into production, likely with very few tweaks over what you see here.
So what do you see here? A QP in a business suit, to sum it up. It's got a beautifully deep bronze paintjob and an interior with the finest wool textile and soft leather upholstery. The lustrous paint repeats on the wheel spokes, and of course some discreet Zegna badges inside and out. The fashion house also worked up some special fitted luggage, as you can see from our gallery of high-resolution photos from the show floor, along with the stock shots, a video and a press release below.

Former BMW M boss and Maserati CEO killed in freak motorcycle accident

Mon, 19 Aug 2013

It's a tragic coincidence that on the same weekend the BMW M4 Coupe Concept was introduced in Monterey, one of the men most integral to BMW's M and Motorsports divisions, Karl-Heinz Kalbfell, was killed in England. Kalbfell, a vintage motorcycle enthusiast, was set to compete in the Lansdowne Classic Series at Brands Hatch and had an accident during a practice session. After going wide at Druids Corner and falling, he was hit by a competitor following close behind and died of his injuries after being transported to hospital.
Kalbfell, an engineer, began his career at BMW in 1977 in the communications department; a decade later he was chairman of BMW M GmbH, overseeing development of some of the cars responsible for the myth of M. In 1994 he was named chairman of BMW Motorsport, and his cap full of feathers includes getting the BMW V12 into the McLaren F1, getting the BMW V8 into two Morgan cars, along with developing BMW's Formula One engine and return to the sport. Not incidentally, he also assumed leadership of Project Rolls-Royce after BMW bought the British marque in 1998, which means he oversaw the Goodwood factory upfit and the creation of the Phantom.
He left Rolls-Royce for a brief stint at Fiat, heading Alfa Romeo and Maserati, then went into consulting for clients like Lotus and Paragon, who built the Artega GT. As Autocar notes, Kalbfell "had an abiding sense that customers needed to be attracted to cars by their aura and reputation, not just their engineering." He will be missed.