1964 Willy's Cj-5 on 2040-cars

Auto blog

Jeep Wrangler likely to get aluminum body, will stay in Toledo

Perhaps more than any other vehicle currently for sale in the United States, the Jeep Wrangler is viewed by purist fans as a vehicle that simply must maintain the status quo. In this case, that means a body-on-frame design, solid axles, a relatively large engine sitting up front and a removable top. It's always been that way, and it always will be.
Maybe.
According to the most recent reports, the next-generation Jeep will continue to soldier forth with a full steel chassis underneath its stamped bodywork. The biggest change, reports Automotive News, will be that said panels will be hewn from aluminum instead of steel, a seismic shift of a transition not unlike what's happened with the new Ford F-150. Because it won't be a unibody, the SUV will likely continue to be assembled in Toledo, OH as it (almost) always has been - the latter has been a source of heartburn in recent weeks for the Northwestern city in the Buckeye State.

Jeep Liberty under investigation for door fires

The Jeep Liberty has already had plenty of attention for possible fires thanks to the first-gen model's fuel tank, but now the midsize Jeep is under the microscope of the National Highway Traffic Safety Administration for another fire-related concern. NHTSA has opened an investigation for the 2012 Liberty after receiving two reports of electrical fires in the driver's door.
According to the investigation summary, around 80,000 vehicles could potentially be affected by this problem. In both reported fires, the drivers noticed smoke and then flames from the master power window switch, and they had to pull to a stop and exit through the passenger side of the SUV. According to Autoguide, there was one injury to a motorist who suffered burned fingers while trying to open the driver's door.
Interestingly, the Dodge Nitro is not yet involved in this investigation, even though it was still around for the 2012 model year; the Nitro ended production in 2011 about a year before the final Liberty rolled off the line for the 2013 model year. Scroll down for the official NHTSA investigation summary.

Chrysler investing $20M in Toledo plant to support 9-speed auto production

In 2011, Chrysler announced a $72-million investment in its Toledo Machining Plant to modernize production of the eight- and nine-speed torque-converters for automatic transmissions made there. That upgrade work won't be finished until Q3 of this year, but Chrysler has already announced a further $19.6-million investment to increase production capacity for the nine-speeders.
The extra units will be necessary because the nine-speed transmission they'll be mated to is going into three popular models: it will debut on the 2014 Jeep Cherokee, then go into the Chrysler 200 and Dodge Dart. The company predicted that this year alone it would sell 200,000 units equipped with the nine-speed tranny, and it is spending some $374 million in addition to the investment in Toledo to upgrade production capacity for it.
The work attached to this new investment won't begin until Q3 of 2014, and it will be finished by the end of that year. There's a press release below with all the details.